ハイポイドギヤの歯当たりパターンに関する研究 : 第1報, 歯当たり算出に必要な基礎諸元

概要

論文の詳細を見る
rights: 本文データは社団法人日本機械学会の許諾に基づきCiNiiから複製したものであるTooth bearing patterns for hypoid gears cannot be described by conventional theory. In gear manufacturing factories, tooth bearing development is still required in order to obtain good tooth bearing patterns. This paper presents a new method for the development of hypoid tooth bearing patterns which differs from the conventional and experimental gear cutting methods. This report makes it possible to obtain accurate hypoid gear dimensions which consist of the mating pressure angles, spiral angles and pitch angles, pitch cones, and principal directions of the gear tooth surfaces. These dimensions are required in the drawing of the tooth bearing patterns.
社団法人日本機械学会の論文
1990-03-25