一般転位インボリュートフェースギヤに関する研究 : 第1報, 理論解析および総合限界線図

概要

論文の詳細を見る
A face gear can be cut with a pinion cutter using a simple attachment fitted to an ordinary gear shaper. Assemblage and adjustment are easy, and the face gear is sufficiently practicable as a substitute for a bevel or hypoid gear. However, the limited face width is the disadvantage of a face gear, because the outside diameter is limited by the narrow tooth edge, and the inside diameter by the undercut and involute interference, This study was designed to effectuate drastic relaxation of the face width limitation by introducing a coefficient of transverse shift as a new design variable for a face gearset. In the lst report of this study, strict theoretical analysis was undertaken for the engagement of the generalized profile-shifted face gearset. A large number of synthetic limit diagrams were prepared on the basis of the theoretical formulas obtained, and the applicability was examined. The results confirmed that the introduction of a coefficient of transverse shift was very effective for the relaxation of the face width limitation for a face gearset.
一般社団法人日本機械学会の論文
1996-02-25