高密度ポリエチレンの後方押出し加工に関する研究
スポンサーリンク
概要
- 論文の詳細を見る
The backward extrusion of high-density polyethylene is experimentally investigated with relation to the effects of extrusion ratio R, semi-cone angle α of the punch nose, and extrusion rate V. The appearance of the extrudates was observed to be greatly affected by R, α and V ; it went bad as R or α increased, or V decreased. Dead material was formed only when α>75゜ and acted as a tip of the front end of the punch. Extrusion pressure P increased as R increased, but decreased as V increased : it was also affected by α. The tensile strength of the extrudates increased as R increased in the axial direction, but it was little affected by R in the hoop direction.
- 一般社団法人日本機械学会の論文
- 1986-09-25
著者
関連論文
- 高分子材料の縦弾性係数に及ぼす環境温度の影響
- 高密度ポリエチレンの液-固相遷移過程状態での押出しによる強度改善 (プラスチック加工の高精度化)
- プラスチック成形加工 21世紀への展望
- プラスチックの成形加工
- 高密度ポリエチレンの二軸延伸加工に関する研究 : 第3報,HDPEの後方押出しと拡管加工に対するエネルギー法の適用
- ポリアミドイミド(PAI)とポリエーテルエーテルケトン(PEEK)の静水圧下における引張特性
- 連載「21世紀の塑性加工に何が求められるか」III : 21世紀の地球環境と塑性加工
- 高分子材料の降伏応力に及ぼす静水圧の影響
- 高分子材料の降伏応力に及ぼすひずみ速度の影響
- プラスチック塑性加工技術の進展と応用技術