Utilizing TiC Cermet in Face-Milling

スポンサーリンク

概要

• 論文の詳細を見る

• A higher production rate of face-milling will be realized if a more abrasion resistant but less tough tool material can be used without breakage. For this purpose, titanium carbide cermet tool material is studied for utilization in steel face-milling. The main problem is to provide the effective land and the proper rake angle to the cutting edge. The land strengthens the cutting edge against the impact, while the proper positive radial rake recovers the sharpness which is lost by the land. Basic studies with single bladed cutters presented enough knowledge for the design of a TiC cermet cutter. According to the basic data, a multi-bladed TiC cermet throw-away cutter was designed and examined in an experimental run. The trial multi-bladed cutter proved a good utility of TiC cermet in steel face-milling.

• 一般社団法人日本機械学会の論文

著者

• HOSHI Tetsutaro

  Department of Production Systems Engineering, Toyohashi University of Technology

• Okushima Keiji

  Department Of Precision Mechanics Kyoto University

• Okushima Keiji

  Department Of Mechanical Engineering Kyoto University

• Hoshi Tetsutaro

  Department Of Precision Mechanics Kyoto University.

• Hoshi Tetsutaro

  Department Of Precision Mechanics Kyoto University

• Okushima K.

  Department of Precision Mechanics, Kyoto University

• Okushima K.

  Department of Mechanical Engineering, Kyoto University

関連論文

• Fundamentals for Vibration Diagnosis by Ground Surface Marks
• Transitional Phenomenon in Metal Cutting
• Utilizing TiC Cermet in Face-Milling
• A Study of Machinability of Metals : Effect of Microstructure of Metals on Cutting Mechanism
• A Study of Machinability of Metals : Effect of Microstructure of Metals on Tool Life and Surface Finish
• On the Applications of Ceramics in Machining
• Thermal Crack in the Carbide Face-Milling Cutter : 1 st Report, Results Obtained from the Fundamental Cutting Experiments
• Measurement of Cyclic Temperature Change of Tool-Chip Interface in Carbide Fly Milling
• Internal Temperature Distribution of the Carbide Fly Cutting Tool
• Thermal Crack in the Carbide Face-Milling Cutter : 2nd Report, Its Significance as a Cause of Tool Failures
• The Effect of the Diameter of Carbide Face-Milling Cutters on their Failures

もっと見る 閉じる

スポンサーリンク