Arch-type Vortex Formed Behind a Normal Plate Placed in Laminar Boundary Layer

スポンサーリンク

概要

• 論文の詳細を見る

• Characteristics of an arch-type vortex formed behind a plate of aspect ratio h/w = 0.8 (h: height, w: width) which is placed vertically in a laminar boundary layer are investigated. Flow visualization and analysis of velocity signals yield the following new understandings. (i) The variation of Strouhal number S_t (=f_cw/U_o) with Reynolds number Re (=wU_o/v) can be classified into three regions. (ii) Arch-type vortex formed behind a plate shows inconsistency in its periodicity and strength, and has no regular mode vortex shedding as in two-dimensional circular cylinders. (iii) Different tendency of Strouhal number distribution against Reynolds number is due to the different time rate of intermittent vortex shedding. (iv) Arch-type vortex formed behind a plate starts to dissipate in the very vicinity downstream of the plate before convectim far downstream.

• 一般社団法人日本機械学会の論文

著者

• Haniu Hiroyuki

  Department Of Mechanical Engineering Kitami Institute Of Technology

関連論文

• Optimum Suppression of Fluid Forces Acting on a Circular Cylinder and Its Effectiveness : Controlled by a Fine Flat Plate
• Vortex Shedding from a Circular Cylinder Placed Vertically in a Laminar Boundary Layer : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
• Fluctuating Forces Acting on Two Square Prisms in Tandem Arrangement (In the Case of Small Free-Stream Turbulence) : Series B : Fluids Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
• Arch-type Vortex Formed Behind a Normal Plate Placed in Laminar Boundary Layer
• Thermochemical Conversion of Sugarcane Bagasse into Bio-Crude Oils by Fluidized-Bed Pyrolysis Technology
• Reduction of Fluid Torque Acting on a Rotating Disk
• Limonene-Rich Liquids from Pyrolysis of Heavy Automotive Tire Wastes

スポンサーリンク