Measurement of Residual Stresses in a Cylinder : 3rd Report, On the Effect of Eccentricity of Holes Bored out in Sachs Method

スポンサーリンク

概要

• 論文の詳細を見る

• The Sachs boring-out method is used for determining axially symmetrical residual stresses in circular cylinders. However, when holes bored out in a circular cylinder layer by layer are not exactly concentric, the above method will not be satisfactorily applicable to estimation of the residual stresses in the cylinder on account of the eccentricity of the holes. Since it is usually accepted that dimensional changes caused by any relaxation of stress are purely elastic, the author analyzes the effect of eccentricity on the deformation of a cylinder from purely elastic theory and gives the numerical evaluations.

• 一般社団法人日本機械学会の論文

著者

• Kawagoe Haruo

  Faculty Of Engineering Tottori University

関連論文

• Studies on the Stability of Pipes Conveying Fluid : (The Combined Effect of a Spring Support and a Lumped Mass)
• Measurement of Residual Stresses in a Cylinder : 1 st Report, Theory for a Short Specimen Cut Off from a Long Cylinder
• Measurement of Residual Stresses in a Cylinder : 2nd Report, Evaluation and Experiment on a Short Specimen Cut Off from a Long Cylinder
• Measurement of Residual Stresses in a Cylinder : 3rd Report, On the Effect of Eccentricity of Holes Bored out in Sachs Method

スポンサーリンク