Influence of Supply Conditions of Grinding Fluids on Grinding Performances of Free In-Feed Plunge Grinding
スポンサーリンク
概要
- 論文の詳細を見る
Influence of the supply conditions of grinding fluids on grinding performances of free in-feed plunge grinding were studied experimentally. This influence was found to be great especially when an emulsion containing less emulsifier was used as the grinding fluid. It was also clarified from the present experiments that the grinding difficulties observed in the case of the emulsion of lower emulsifier concentration in the previous experiment were attributable mainly to the bad supply condition of the fluid, and that these difficulties could be overcome by the improvement of the supply conditions. When the grinding fluid performance is tested with use of such a grinding method as used in this experiment, it is necessary for the proper evaluation of the fluid that particular attention should be paid to the selection of the supply methods or conditions of the fluid.
- 一般社団法人日本機械学会の論文
著者
-
Tamura Hisao
Kawasaki Factory Hitachi Ltd.
-
FURUICHI Ryozo
Osaka City University
-
NAKAYAMA Mamoru
Osaka City University
-
DOI Toshihiro
Osaka City University
-
Doi Toshihiro
Department Of Mechanical Engineering Osaka City University.
-
Furuichi Ryozo
Department Of Mechanical Engineering Osaka City University
-
Nakayama Mamoru
Department Of Mechanical Engineering Osaka City University
関連論文
- Influence of Supply Conditions of Grinding Fluids on Grinding Performances of Free In-Feed Plunge Grinding
- Influence of Dressing Conditions of Grinding Wheel on Grinding Fluid Performance in Free Infeed Plunge Grinding