Study on Precision Cylindrical Lapping : on the Condition for Modification of Roundness Error

スポンサーリンク

概要

• 論文の詳細を見る

• This paper discusses analytically on the condition for modification of the work roundness error and improvement to the value of about 0.1 μm by a simple conventional cylindrical lapping method, considering that it has been very difficult to machine a cylindrical workpiece at its top position supported with two free rotating rollers. The analysis points out that there is a suitable machining condition for modification of roundness error by which the effect of the random and periodic deflections of the supporting roller surface and its rotating axis on the work roundness can be decreased. The paper describes the analytical result and a few experiments carried out for confirmation yielding an out-of-roundness value of 0.2 μm.

• 一般社団法人日本機械学会の論文

著者

• Shinmura Takeo

  Faculty Of Engineering Utsunomiya University

• AIZAWA Toshio

  Faculty of Engineering, Utsunomiya University

• Aizawa Toshio

  Faculty Of Engineering Utsunomiya University

関連論文

• Development of a New Internal Finishing Process Applying Magnetic Abrasive Finishing by Use of Pole Rotation System
• A New Internal Finishing Process by Applying Magnetic Abrasive Finishing through the Use of the Pole Rotation System -Processing Principle with a Few Finishing Characteristics-
• The Development of Magnetic-abrasive Finishing and Its Equipment by Applying a Rotating Magnetic Field
• Study on a New Internal Finishing Process by the Application of Magnetic Abrasive Machining : Internal Finishing of Stainless Steel Tube and Clean Gas Bomb
• Study on Precision Cylindrical Lapping : on the Condition for Modification of Roundness Error
• Study on Free Form Surface Finishing by Magnetic Abrasive Finishing Process : 1st Report, Fundamental Experiments

スポンサーリンク