Flow Properties of Stable Slurries : (1st Report, Experiment)
スポンサーリンク
概要
- 論文の詳細を見る
On the flow properties of stable slurries of several polymer particles, experiments were carried out, using a Couette-type rotational viscometer and two capillary viscometers, in the range of concentration : 0〜45 (%) and rate of shear : 5〜7×10^3 (sec^<-1>), changing the size of particles, the viscosity of suspending liquids and the temperature. The results obtained are as follows. (1) The flow properties of slurries are not independent of the kind of viscometer (rotational or capillary) and the apparent viscosity by the capillary viscometer is lower than one by the rotational viscometer, at the same rate of shear. (2) P.M.M.A.-slurry is a Newtonian fluid in the range of concentration from 0 to 20 (%). But, P.E.-and P.V.C.-slurries become non-Newtonian fluids at lower concentrations. (3) Oliver's constant of P.M.M.A.-slurry is 2.60 and its value agrees with the results of experiments by others.
- 一般社団法人日本機械学会の論文
著者
-
Tachibana Motoyoshi
Faculty Of Engineering Fukui University
-
Tachibana Motoyoshi
Faculty Of Technology Tokyo Metropolitan University
-
IWANAMI Shigezo
Faculty of Technology, Tokyo Metropolitan University
-
Iwanami Shigezo
Faculty Of Technology Tokyo Metropolitan University
関連論文
- Steady Laminar Flow in the Inlet Region of Rectangular Ducts
- A Useful Numerical Analysis Method for the Dynamic Characteristics of Fluid Film Lubrication : The Case of Incompressible Fluid Lubrication
- Flow Properties of Stable Slurries : (2nd Report, Analysis)
- Basic Studies on Hydraulic Capsule Transportation : Part 1. Loss due to Cylindrical Capsules Set in Circular Pipe Flow
- Flow Properties of Stable Slurries : (1st Report, Experiment)
- Basic Studies on Hydraulic Capsule Transportation : Part 2. Balance and Startup of Cylindrical Capsule in Rising Flow of Inclined Pipeline
- On the Drag of a Sphere In Polymer Solutions
- Study on Flow Characteristics in Right-Angled Pipe Fittings : 1st Report, On Case of Water Flow
- Study on Flow Characteristics in Right-Angled Pipe Fittings : 2nd Report, On Case of Slurries in Hold up Flow