Problems on the Finite Hollow Cylinders under the Axially Symmetrical Deformations
スポンサーリンク
概要
- 論文の詳細を見る
In this paper, the authors consider three-dimensional elastic problems on a circular hollow cylinder under the axially symmetrical deformations. The problems on the cylinder are classified into twelve fundamental cases according to boundary conditions. The general solution to various problems was obtained by expanding each elementary formula to the condition in a form of a Fourier and Bessel series and by superposing the stress systems. As numerical examples, the stress distributions and deformations of a finite hollow cylinder subjected to uniform band pressure were calculated by the digital computer of Kanazawa University (NEAC-2230). This pressure is distributed circularly over the end-surface and over the middle zone of the inner or outer-surface.
- 一般社団法人日本機械学会の論文
著者
-
Oda Juhachi
Faculty Of Engineering Kanazawa University
-
Shibahara Masao
Faculty Of Engineering Kanazawa University
関連論文
- On Clamping Stiffnesses of Abutments in Bolted Joints
- On a Technique to Obtain an Optimum Strength Shape by the Finite Element Method : Application to the Problems under Body Force
- Three-Dimensional Stress Analysis of Rotating Compound Cylinders
- On Shrink-Fit Stresses between an Infinite Cylinder and a Finite Hollow Cylinder
- Simulation of Elastic Modulus and Poisson's Ratio of Spheroidal Graphite Cast Iron
- Three-Dimensional Stress Analysis of Rotating Hollow Cylinders
- An Automatic Analysis of the Elastic Contact Problems By the Point-Matching Method
- Application of the Point-matching Method to the Three-Dimensional Elastic Contact Problems
- Stress Analysis of Shrink-Fit Cylinders Under Torsion
- Estimation of Fracture Behavior of Porous Materials
- Response of an Infinite Elastic Body to Traveling Load In a Cylindrical Hole
- Response of Elastic Media with a Cylindrical Cavity to Dynamic and Impact Load
- Application of the Integral Equation Method to the Elastodynamic Boundary-value Problems
- Analysis of Interference Effects of Auxiliary Notches by the Integral Equation Method
- Diffraction of Steady Stress Waves by Arbitrary Shaped Discontinuities in Elastic Medium
- Problems on the Finite Hollow Cylinders under the Axially Symmetrical Deformations
- Dynamic Response of a Beam with a Crack Subjected to Four-point Impact Bending
- The Dynamic Stress Intensity Factor of Anisotropic Plates with a Crack in the Matrix : Series A : Solid-Mechanics Strength of Materials
- Stress Analysis of L Shape Joints and Evaluation of Joint Strength : Series A : Solid-Mechanics, Strength of Materials
- On a Technique to Obtain an Optimum Strength Shape of an Axisymmetric Body by the Finite Element Method
- On a Technique to Obtain an Optimum Strength Shape by the Finite Element Method