The Cutting Mechanism of Honing
スポンサーリンク
概要
- 論文の詳細を見る
For the purpose of inquiring into the cutting mechanism of fine-grain abrasive stones in the honing, an experimental research has been carried out with an external honing apparatus. Concerning the cutting speed, the best cutting efficiency is obtained at a cutting speed of 40 m/min. The cutting direction angle of 40°〜50°is the most suitable, and the cutting direction angle is the most decisive factor in the cutting mechanism of honing. As to the bond hardness, it is suitable to use the harder stone. Comparing the honing with the superfinish, the most suitable values of cutting direction angle and cutting speed are same in both cases. But the cutting efficiency of superfinish is 5〜10 times that of honing, and the stone wear per unit amount of stock removal of honing is slightly smaller than that of superfinish.
- 一般社団法人日本機械学会の論文
著者
-
SASAKI Tokio
Faculty of Engineering, Kyoto University
-
Okamura Kenjiro
Faculty Of Engineering Kyoto University
-
Sasaki Tokio
Faculty Of Engineering Kyoto University
関連論文
- Fundamental Research on Gear Lubrication : 4th Report, Analysis on the Formation of Oil Film and Its Dynamic Phenomena in Mating Gears
- Fundamental Research on Gear Lubrication : 3rd Report, Basic Analysis on Dynamic Phenomena of Oil Film
- Fundamental Research on Gear Lubrication : 6th Report, Fundamental Analysis on Discontinuous Phenomena (the Journal and the Transactions of the Japan Society of Mechanical Engineers)
- Fundamental Research on Gear Lubrication : 3rd Report, Theoretical Analysis on the Effect of Discontinuous Load, and Correlation between the Gear Test and the Roller test
- Fundamental Research on the Gear Lubrication : 2nd Report, Lubrication Performance on Gear-Tooth Surface
- Research on Wave Phenomena in Hydraulic lines : 1st Report, Unstteady Liquid Flow in a Uniform Pipe
- Research on Wave Phenomena in Hydraulic Lines : 2nd Report, Unsteady Liquid Flow in a Tapered Pipe
- Theory of Grease Lubrication of Cylindrical Rooler Bearing
- The Cutting Mechanism of Honing
- The Rotating Mechanism of Rolling Element by Minute Vibration and Its Application
- Lubrication of High Speed Tapered Roller Bearing by Atomized Oil
- Research on Controlled Hydrostatic Bearing (the Journal and the Transactions of the Japan Society of Mechanical Engineers)
- On the New Control Method for Magnetic Bearing
- Theoretical Study of Hydrostatic Thrust Bearings
- Fundamental Research on Gear Lubrication
- The Cutting Mechanism of Abrasive Grain : (1st Report, Experimental Observations of the Stock Removal and the Swell-up Phenomena)