On the Flow of Pulverized Coal in the Exhauster
スポンサーリンク
概要
- 論文の詳細を見る
In the exhauster that feeds the boiler furnace with fuel in the mill, the blades of the exhauster wear out violently due to the pulverized coal-air mixture treated in it. As a countermeasure against this wear phenomenon, it is more effective to adopt lacerated blades instead of common straight blades than to change the material of blades. This report aims to provide a basis of wear-proof measure by grasping the motion of the pulverized-coal in the exhauster. As the result of the experiment, the following conclusions were drawn : (1) In case of the straight blades, most of the powder flows along the blade surface. (2) In case of the lacerated blades, the powder flows from the tips of lacerated teeth drawing a parabolic line, but hardly touching the blade surface.
- 一般社団法人日本機械学会の論文
著者
-
NISHIKAWA Kaneyasu
Faculty of Engineering, Kyushu University
-
Yamagata Kiyoshi
Faculty Of Engineering Kyushu University
-
KAWANO Michihiko
Faculty of Engineering, Kyushu University
-
Nishikawa Kaneyasu
Faculty Of Engineering Kyushu University
-
Kawano Michihiko
Faculty Of Engineering Kyushu University
関連論文
- Heat Transfer in an Open Thermosyphon
- The Effect of Radiation on Film Boiling Heat Transfer : Plane Wall Parallel to Upward Vertical Flow
- Forced Convection Film Boiling Heat Transfer from a Horizontal Cylinder to Liquid Cross-flowing Upward : 2nd Report, Subcooled Liquid
- Forced Convection Film Boiling Heat Transfer from a Horizontal Cylinder to Liquid Cross-flowing Upward : 1st Report, Saturated Liquid
- Flow Simulation of Forced-Flow Boiling with Air-Water Two-Phase Fluids : 1st Report, On the Distribution of Bubbles
- Investigation of Surface Film Boiling under Free Convection : 2nd Report, Effect of Diameter of Horizontal Cylinder and System Pressure
- Experimental Study on the Mechanism of Transition Boiling Heat Transfer : 1st Report, Measurements of Local Solid-Liquid Contact and Temperature Fluctuations on the Heating Surface
- On Ripple of Annular Two-Phase Flow : 3.Effect of Liquid Viscosity on Characteristics of Wave and Interfacial Friction Factor
- On Ripple of Annular Two-Phase Flow : 1. Statistical Characteristics of Ripples
- Investigation into the Statistical Characteristics of Bubbles in Two-Phase Flow : 2nd Report. Application and Establishment of Electric Resistivity Probe Method
- Investigation into the Statistical Characteristics of Bubbles in Two-Phase Flow : 1st Report. Fundamentals of the Instrumentation Using the Electric Resistivity Probe Technique
- Two-Phase Flow Characteristics in the Disturbed Flow Region after Mixing Air and Water
- Analysis of Turbulent Forced Convection Heat Transfer to a Supercritical Fluid
- Nucleate Boiling at Low Liquid Levels
- Growth and Collapse of Bubbles in Nucleate Boiling
- Heat Transfer in Surface Boiling under Free Convection
- On the Pulsation Phenomena in Gas-Liquid Two-Phase Flow : Relationship between Pulsating Pressure and Flow Pattern in Upward Two-Phase Flow
- Two-Phase Flow in Spirally Grooved Tubes
- On the Flow of Pulverized Coal in the Exhauster
- Time Variation of Nucleate Boiling Heat Transfer of Water
- Investigation of Surface Film Boiling under Free Convection : (1st Report, An Experiment on Small Wires)
- Boiling Heat Transfer at the Coexistence of Nucleate and Film Regions
- Photographic Study of Saturated Free Convection Stable Film Boiling
- Experimental Study on the Mechanism of Transition Boiling Heat Transfer : 2nd Report, The Relation between the Behavior of Growing Vapor Bubble and the Mechanism of Heat Transfer