Fluid Flow and Heat Transfer around Two Circular Cylinders of Different Diameters in Cross Flow
スポンサーリンク
概要
- 論文の詳細を見る
The heat transfer mechanism in separated region of a cylinder immersed in a free stream with non-homogeneous and unisotropic turbulence was made clear experimentally in relation to the wake formation process near the cylinder and the flow behavior in the layer close to the cylinder wall. An experiment was conducted in the subcritical flow region. The appearance of a second peak of heat transfer coefficients in separated region is due to the existence of a three-dimensional unsteady flow close to the cylinder surface and the decrease of heat transfer coefficients in near stagnation region is caused by the formation of an apparent turbulent separation point.
- 一般社団法人日本機械学会の論文
著者
-
KUMADA Masaya
Faculty of Engineering, Gifu University
-
Kumada Masaya
Faculty Of Engineering Gifu University
-
HIWADA Munehiko
Faculty of Engineering,Gifu University
-
TAGUCHI Tatsuhisa
Matsushita Denki Sangyo
-
MABUICHI Ikuo
Faculty of Engineering,Gifu University
-
Mabuichi Ikuo
Faculty Of Engineering Gifu University
-
Hiwada Munehiko
Faculty Of Engineering Gifu University
関連論文
- Studies on the Convective Heat Transfer from a Rotating Disk : 3rd Report, Heat and Mass Transfer in a Laminar Flow about a Rotating Disk with Suction or Injection in the Axial Stream
- Studies on Heat Transfer to Turbulent Jets with Adjacent Boundaries : 3rd Report, Mass Transfer to Plane Turbulent Jet Reattached on an Offset Parallel Plate
- Fluid Flow and Heat Transfer around Two Circular Cylinders of Different Diameters in Cross Flow
- Effect of Free-Stream Turbulence on Heat Transfer Characteristics in the Reattachment Region on the Bottom Surface of a Backward-Facing Step : For Different Angles of Separation : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysi
- Studies on the Enhancement of Forced Convective Heat Transfer in Three-Dimensional Rib-Roughened Tubes : 2nd Report, Staggered Arrangement : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- Studies on the Enhancement of Forced Convective Heat Transfer in Three-Dimensional Rib-Roughened Tubes : 1st Report, In-line Arrangement : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- Flow around a Finite Circular Cylinder on a Flat Plate : Cylinder height greater than turbulent boundary layer thickness
- Some Characteristics of Flow Pattern and Heat Transfer past a Circular Cylindrical Cavity
- Fluid Flow and Heat Transfer around Two Circular Cylinders
- Full-Coverage Film Cooling on Curved Walls : 2nd Report, Mass Transfer Coefficients on a Concavely Curved Wall : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical, Properties
- Basic studies on a fluidized Bed Heat Exchanger : 1st Report, Heat Transfer From Single Row Horizontal Cylindrical Tubes Immersed In Floating Low Density Particles : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- Basic Studies on Fluidized Bed Heat Exchanger (Heat Transfer from Single Row of Horizontal Rectangular Tubes Immersed in Floating Low Density Particles) : Heat Transfer, Power, Combustion, Thermophysical Properties
- Studies on Heat Transfer to Turbulent Jets with Adjacent Boundaries : 1st Report, Flow Development and Mass Transfer in Plane Turbulent Wall Jet
- Studies on Heat Transfer to Turbulent Jets with Adjacent Boundaries : 2nd Report, Mass Transfer to Plane Turbulent Jet Reattached on an Inclined Flat Plate
- Studies on the Heat Transfer of Impinging Jet : 1st Report, Mass Transfer for Two-Dimensional Jet of Air Impinging Normally on a Flat Plate
- Studies on the Convective Heat Transfer from a Rotating Disk : 4th Report, Laminar Heat Transfer from a Disk with a Step-wise Discontinuity in Surface Temperature Rotating in Uniform Forced Stream