Bending Stress Analysis of Idle Gear with Thin Rim : Effect of Rim Thickness on Stresses
スポンサーリンク
概要
- 論文の詳細を見る
Stress distributions in planet gears with a thin rim are analyzed by the photoelastic method and the following results are obtained: Although the position of the maximum stress occurring on a fillet varies with both the tooth load and the radial clearance between rim and gear shaft, it may be sufficient to consider the maximum tensile and compressive fillet stresses in the planet gear concerning the bending strength. In the case of a thin rim, if the radial clearance increases by more than a certain value, the stress amplitude on a fillet may increase rapidly and the value of the clearance may decrease when the rim thickness decreases.
- 一般社団法人日本機械学会の論文
著者
-
Ishida Takeshi
Faculty Of Engineerng Yamaguchi University
-
Ishida Takeshi
Faculty Of Engineering Yamaguchi University
-
HIDAKA Teruaki
Faculty of Engineerng, Yamaguchi University
-
TAKIZAWA Hideharu
Mitsubishi Motors Co.
-
TAKIZAWA Hideharu
Nagoya Motor Vehicles Works, Mitsubishi Motors
-
Hidaka Teruaki
Faculty Of Engineerng Yamaguchi University
-
Hidaka Teruaki
Faculty Of Engiineering Yamaguchi University
関連論文
- Deflection along Line of Action of Idle Gear with both Thin Rim and Radial Clearance between Rim and Gear Shaft : Series C : Vibration, Control Engineering, Engineering for Industry
- Theoretical analysis of nominal stress in rim of planet gear
- Bending Stress Analysis of Idle Gear with Thin Rim : Effect of Rim Thickness on Stresses
- Bending Stress Analysis of Idle Gear with Thin Rim : Effects of Tooth Load and Radial Clearance between Rim and Gear Shaft on Stresses
- Effect of Addendum Modification Coefficient on Bending Strength of Internal Gear
- Effects of Rim Thickness and Number of Teet on Bending Strength of Internal Gear
- On the Relation between the Run-Out Errors and the Motion of the Center of Sun Gear In a Stoeckicht Planetary Gear
- Dynamic Behavior of Planetary Gear : 1st Report Load Distribution in Planetary Gear
- Analysis of Dynamic Tooth Load on Planetary Gear
- Effects of Errors of Elements on Load Distribution in Planetary Gears with Various Load Equalizing Mechanisms
- Dynamic Behavior of Planetary Gear : 7th Report, Influence of the Thickness of the Ring Gear
- Dynamic Behavior of Planetary Gear : 6th Report, Influence of Meshing-Phase
- Dynamic Behavior of Planetary Gear : 5th report, Dynamic Increment of Torque
- Dynamic Behavior of Planetary Gear : 4th Report, Influence of the Transmitted Tooth Load on the Dynamic Increment Load
- Dynamic Behavior of Planetary Gear : 2nd Report, Displacement of Sun Gear and Ring Gear
- Dynamic Behavior of Planetary Gear : 3rd Report, Displacement of Ring Gear in Direction of Line of Action