Flow Past Cone Placed on Flat Plate
スポンサーリンク
概要
- 論文の詳細を見る
This paper presents an experimental investigation on the flow past a cone placed on a float plate and its wake. The vertex angle of the cone was varied 60°, 90°, 120° and 150°. The surface-pressure distributions on the cone and the flat plate, the velocity and the static pressure in the wake were measured, and the separation and the vortex formation were observed by visual means. The main results are as follows : (1) There occur necklace-like vortices around the cone of vertex angle 60°~120°, and horse-shoe vortices generated behind the cone are shed downstream periodically. (2) The lift acting on the cone and the drag decrease with an increase in the vertex angle. (3) There exists a region of negative wake, which becomes maximum at a downstream distance of about twelve times the height of cone.
- 一般社団法人日本機械学会の論文
著者
-
Kataoka Shin-ichi
Nippon Steel Corporation
-
OKAMOTO Tetsushi
College of Science and Engineering, Aoyama Gakuin University
-
YAGITA Miki
Tokyo Institute of Technology
-
Okamoto Tetsushi
College Of Science And Engineering Aoyama Gakuin University
関連論文
- Flow Past Cone Placed on Flat Plate
- Effect of Side Walls of Wind-Tunnel on Flow around Two-Dimensional Circular Cylinder and Its Wake
- Large-scale Structures in the Wake a Circular Cylinder
- Experimental Investigation of the Wake of a Wedge
- Experimental Investigation on the Boundary-Layer Flow over a Rotating Cone-Cylinder Body in a Uniform Stream
- The Experimental Investigation on the Flow Past a Circular Cylinder of Finite Length Placed Normal to the Plane Surface in a Uniform Stream
- Oblique Impingement of Two Turbulent Plane Free Jets
- FLOW PAST CIRCULAR CYLINDER OF FINITE LENGTH PLACED NORMAL TO GROUND PLANE IN UNIFORM SHEAR FLOW
- INTERACTION OF TWIN TURBULENT CIRCULAR JET
- Vector Control of Two-dimensional Turbulent Free Jet by Both-side Flaps
- Vector Control of Two-dimensional Turbulent Free Jet by One-side Flap