On the Method of Measuring Strain by Use of Diffraction at Mis-matched Moire Fringes
スポンサーリンク
概要
- 論文の詳細を見る
In the usual moire method and the multiplication method, the sensitivity to deformation is not sufficient at present. Then, how to increase the sensitivity is studied. In the measurement of a usual sheet metal specimen, moire fringes with large mis-match is photographed on a film at first. Such fringes are equivalent to grating lines on the specimen, as thy displace corresponding to strain, and they can be amplified by applying the multiplication method to that film. When strain is expressed by two beam interference fringes, one of the beams is tilted by a small amount, then fine fringes are obtained. They are equivalent to moire fringes with large mis-match and the multiplication method can be applied. Applications in various conditions have been shown. Consequently, concerning a sheet metal, measurement of elastic-plastic strain (ε⋍ 0.001) becomes possible and in the special condition that the surface of a specimen has been finished mirror-like, elastic strain (ε⋍ 0.001) can be measured.
- 一般社団法人日本機械学会の論文
著者
-
Kato Kazunori
Faculty Of Engineering Tokyo Institute Of Technology
-
Morita Katsuhiro
Nissan Motor Car Co. Ltd.
-
Murota Tadao
Faculty Of Engineering Miyazaki University
-
Murota Tadao
Faculty Of Engineering Tokyo Institute Of Technology
関連論文
- Some Investigations on the Methods of Measuring 3-Dimensional Plastic Deformations by Laser
- Analysis of Temperature Distribution in Caliber Rolling of a Bar
- Analysis of Rolling of Bars by the Energy Method Using Finite Element Division : (Analysis of Square-Oval Pass)
- Analysis of Rolling of Angles by Energy Method Using Finite Element Division : Solid-Mechanics, Strength of Materials
- Analysis of Rolling of Bars by the Energy Method Using Finite Element Division
- Improvement of the Energy Method Using Finite Element Division and Application to Flat-rolling
- On the Method of Measuring Strain by Use of Diffraction at Mis-matched Moire Fringes
- Improvement of the Method of Measuring Shear Strain Using Interferometry of Diffraction Beams