18-8ステンレス鋼のリーマ加工 : 仕上面あらさと寸法精度について

概要

論文の詳細を見る
This paper describes the conditions to get good surface roughness and the accuracy of reamed hole on 18-8 stainless steel. As the built-up edge affects much the finish and existence of built-up edge on 18-8 stainless steel was not clear, existence was investigated at low cutting speed before the experiment of reaming, and the built-up edge was recognized at such a low cutting speed on 18-8 stainless steel. So, it is neccessary for good finish to prevent the growth of built-up edge as small as possible at reaming on 18-8 stainless steel. For this purpose sulphurized oil is effective as the cutting fluid. Concerning reaming conditions, proper reamer angles, reamer dimensions, cutting speeds and feed speeds can be obtained.
一般社団法人日本機械学会の論文
1964-12-25