Holographic Measurement of Evaporating Diesel Sprays at High Pressure and Temperature : Heat Transfer, Combustion, Power,Thermophysical Properties
スポンサーリンク
概要
- 論文の詳細を見る
Application of the pulsed laser holography technique was made to observe a diesel spray injected into a high pressure bomb. Two different holography techniques, that is, single-pulsed laser holography and double-pulsed holographic interferometry were adopted in this study. Shadowgraphs, schlieren photographs and micrographs of a reconstructed image of the spray were taken. The spray width and equivalence ratio of fuel droplets were microscopically measured. The fuel droplets and vapor around the spray in a high pressure and temperature atmosphere could be observed by single -pulsed laser holography. Interference fringes were observed along the spray edge by double-pulsed holographic interferometry. double-pulsed holographic interferometry made the image of the evaporating spray at high temperature clearer than the single-pulsed laser holography. The spray width had a tendency to decrease as the atmospheric temperature was increased. Some droplets were observed around the spray up to a pressure of 3.1 MPa and a temperature of 773 K.
- 一般社団法人日本機械学会の論文
著者
-
HIROYASU Hiroyuki
Department of Mechanical Engineering, University of Hiroshima
-
NISHIDA Keiya
University of Hiroshima, Graduate School of Engineering
-
Nishida Keiya
Department Of Mechanical Engineering University Of Hiroshima
-
Hiroyasu Hiroyuki
Department Of Mechanical Engineering University Of Hiroshima
-
Murakami Naoki
Kawasaki Heavy Industries Ltd.
-
MURAKAMI Naoki
University of Hiroshima
-
HIROYASU Hiroyuki
University of Hiroshima
-
Nishida Keiya
University Of Hiroshima
関連論文
- Optical Measurement of Tip Penetration of a Diesel Fuel Spray : Development of Measuring Instrument
- Fuel Injection Strategies to Enhance Evaporation in D.I. Diesel Sprays : Effect of Injection Pressure, Nozzle Hole Diameter and Split Injection
- Characterization of Liquid Jet Atomization across a High-Speed Airstream
- Mean Drop Diameter of a Diesel Spray in a Vaporizing Process
- Evaporating spray and flame distributions in the combustion chamber of a direct injection diesel engine
- Steady Test of In-cylinder Air Motion of Engine with LDV
- Measurements of Breakup Length in High Speed Jet
- Experimental Study on Evaporation and Combustion of Single Coal-Slurry Droplets (Behavior on a Hot Surface in an Elevated-Temperature Environment)
- Measurement of Soot Concentration in Turbulent Diffusion Flames
- Measurements of Fuel Vapor Concentration in a Diesel Spray by Image Analysis of a Reconstructed Hologram
- Holographic Measurement of Evaporating Diesel Sprays at High Pressure and Temperature : Heat Transfer, Combustion, Power,Thermophysical Properties
- Effect of Split Injection Pattern on Combustion and Emission Characteristics of D.I. Diesel Engine
- SC3-3: Mixture Formation Process of Wall-Impinging Spray by D.I. Gasoline Injector : Comparison between Experiment and CFD Calculation(SC: Spray and Spray Combustion,General Session Papers)
- AMBIENT GAS MIXING PROCESS OF D. I. DIESEL SPRAY