鋼線の疲労強度に及ぼす加工硬化および残留応力の影響

概要

論文の詳細を見る
Since it is difficult to separate the contribution of residual stress to the fatigue strength from those of other factors such as work-hardening or size effect, no ultimate conclusion has yet been drawn on the effect of residual stress on the fatigue strength. So, the present investigation was designed to clarify the effects of longitudinal residual stress and work-hardening produced by drawing or surface rolling on the fatigue limit and life under rotating bending of carbon steel wire. Two kinds of testing material were used in this study. One is 0.8% carbon piano wire drawn at various additional reduction, and the other is carbon tool steel surface-rolled after annealing. The distributions of longitudinal residual stress and hardness over the cross section were measured. And the tensile test and the fatigue test under rotating bending were carried out for each specimen. From these experiments, the following conclusions were obtained : (1) The relationship between the number of cycles to failure N and the stress amplitude σ can be expressed as N=C/(A-e^<-Bσ+mΔσ_B-nΔσ_r>) where Δσ_B and Δσ_r are the changes in tensile strength and maximum longitudinal residual stress at outer layer of the specimen due to drawing or surface-rolling, respectively, and A, B, C, m and n are constants dependent upon the material and working conditions. The fatigue strength of a material received cold working can be calculated accurately by this equation. (2) The residual stress influences the fatigue limit and life considerably but its influence is in a much less degree than that of work-hardening, and their ratio is about 1 : 3.
社団法人日本材料学会の論文
1973-10-15

鋼線の疲労強度に及ぼす加工硬化および残留応力の影響

スポンサーリンク

概要

著者

関連論文

スポンサーリンク