高分子物質のころがり摩擦とすべり摩擦
スポンサーリンク
概要
- 論文の詳細を見る
The coefficient of rolling friction for a hard sphere and a cylinder over a polymeric material are derived as a function of mechanical loss. A few assumption were made to clarify the quantitative relation between rolling friction and dynamic modulus of polymeric material. Viscoelastic properties of polymeric material are represented by the generalized Voigt model. Contact deformation of base material owing to the rolling object is assumed to be a periodic phenomenon. From this assumption, the strain and stress for surface deformation is expressed by Fourier series and the stress is also obtained as a function of the dynamic modulus. Spectrum of the relaxation time of polymeric materials is assumed to be moderate and this leads to the correspondence between the rolling velocity and the angular frequency of the dynamic modulus. The coefficient of rolling friction for a rigid sphere is obtained as follows, λ_s=β_s(W/E)^<1/4> r^<-3/4>, where W, R, and E_1 are the load, the radius of the sphere, and the real component of complex the dynamic modulus, respectively. β_s is a function of mechanical loss. For a small range of mechanical loss, β_s is linearly proportional to mechanical loss. λ_s is entirely proportional to mechanical loss. Temperature dependence of λ_s is explained by that of mechanical loss and modulus E_1. The rolling velocity corresponds to the angular frequency of dynamic modulus and correspondence between them is obtained as follows v=0.7(Wr/E_1)^<1/4> ω. From these relations, the coefficient of rolling friction for any temperature or any rolling velocity can be calculated from the dynamic data, or the dynamic data can be presumed from the rolling friction measurement. Consistency of the rolling frictional measurement for several polymers and theoretical results is quantitatively very good. The coefficient of sliding friction for a hard sphere over a polymeric materials were measured. Temperature dependence of sliding friction of NBR resembles that of mechanical loss. Above glass temperature, however, it deviates from the tendency of mechanical loss curve. This may be due to the ploughing effect
- 社団法人日本材料学会の論文
- 1967-07-15
著者
関連論文
- 結晶性高分子の緩和機構 : 結晶性高分子の構造とレオロジー
- (3-3) ポリエチレンの疲労機構
- 4p-RH-1 高圧下における高分子の分子形態
- 高分子物質のころがり摩擦とすべり摩擦
- 31F8 一次元金属のエネルギー準位
- 結晶性高分子の非線型粘弾性 : 高分子固体のレオロジー
- 高圧下における高分子のレオロジー
- 高圧下における高分子構造と物性
- 結晶性高分子の粘弾性
- 高圧下の高分子の構造と物性
- タイトル無し