フィルムの多軸引張衝撃特性
スポンサーリンク
概要
- 論文の詳細を見る
The testing methods of characterizing the impact behavior of film materials can be classified into two types ; the uniaxial tensile impact tests and those multiaxial. The former are of theoretical interest on account of their analytical simplicity, but are often open to question regarding their practical use. The conventional standard tests which fall on the latter category, on the other hand, are widely used because of their good correspondence to the actual impact situations encountered, yet very few results of their analytical studies have so far been announced. In this paper the authors report a newly designed impact test of more practical significance, and propose some approaches to the analysis of the experimental data. The feature of this apparatus is that films are tested by allowing a membrance-shaped specimen attached to the ram to fall on the semispherically edged mandrel, and thereby to be pierced and fractured, and that the load-deflection curves can be provided by the synchroscope through the load-cell connected to the mandrel. In an attempt to determine the impact characteristics from the diagrams obtained, the authors set up two approximate expressions for the stresses from the different standpoints, by which the ultimate impact strengths were calculated ; one deduced from the deflection pattern and the other on the analogy of the thin plate with large deflection problem in the theory of elasticity. The static penetration tests with the same jig and the static tensile tests on an Instron type tester were also conducted to compare the applicability of the two equati ons above mentioned. The results show that, for the film materials such as polyethylene and polypropylene which show large ultimate elongation, the stress equation based on the scheme provides a good basis for the analysis, while to polystylene and cellophane which exhibit only little elongation at break, the stress equation based on the elastic membrane analogy can be applied more successfully.
- 社団法人日本材料学会の論文
- 1968-09-15
著者
関連論文
- フィルムの多軸引張衝撃特性
- プラスチックスの引張衝撃特性
- チューインガムベースの動的針入度試験
- 接着型抵抗線ひずみゲージをプラスチックスに使用する場合の問題について
- 最新プラスチック射出成形技術--一段と高性能化する射出成形機、ますます多彩化する複合射出プロセス
- ハイブリッド成形 (特集 未来志向型成形加工技術の開発と応用展開)
- 成形加工の新展開
- 成形加工による高性能化 (熱可塑性高分子の高性能化)
- 産業界の技術展望 成形加工技術
- 多層成形特集にあたって
- 成形加工による高性能化