内地鐵鑛石使用と熔鑛爐に於ける脱硫の問題(第 1 報)
スポンサーリンク
概要
- 論文の詳細を見る
Since the war we have operated and produced pig iron with the average content of sulphur running up to 0.17% in 1946. Before charging the domestic ores the average content of sulphur in the charged raw material was about 12 to 14 kg per ton of pig iron tapped, but recently it has increased up to 25 to 30 kg. Generally 70 to 75% of the sulphur runs out with the slag and 20 to 25% of it with the gas. The average content of sulphur in the coking coal was 0.7% and practically none of the sulphur decreased by washing nor coking. The content of sulphur were generally large in the fine and sintered ore under 10 mm sizes. Generally the ratio of desulphurization by sintering is from 80 to 90% and it is possible to make it over 90% by improving the method of crushing and screening. To desulphurize by briquetting it is necessary to roast it up to 1200゜C. By using the cement rotary kiln we found out that it is possible to desulphur the lump ore from 70 to 80%. Desulphurization within the blast furnace is 94 to 95% which gives same ratio and shows no differnece whether it be foreign or domestic. Decrease in the blast pressure and the furnace temperature give a bad effect on desulphurization. It is desireable to have a content of 1.0 to 1.5% of Mn in the pig iron and a basicity over 1.3 in the slag. After tapping about 25 to 30% are desulphurized in the ladle on the way to the pig casting machine and about 30 to 35% when the molten pig are transfered to the open hearth plant by way of dead mixer. It is also possidle to desulphurize 40 to 60% by adding 3 to 5 kg. of soda ash per ton of pig iron, but at present soda ash are not available. About 15% of the sulphur are removed by slagging off in the dead mixer. We have come to the conlusion that in order to reduce and refine domestic iron ores it is best to screen it into lump and fine ores and then give the desulphurizing treatment accordingly. This is not impossible but it requires tremendous effort and time.
- 社団法人日本鉄鋼協会の論文
- 1948-07-25
著者
関連論文
- 最近の八幡製鐵所に於ける製銑作業に就て
- 7 最近の八幡に於ける製銑作業について(日本鐵鋼協會第 47 囘講演大會講演大要)
- 最近に於ける本邦熔鑛爐作業の進歩
- 熔鑛爐内に於ける硫黄の擧動について
- 内地鐵鑛石使用と熔鑛爐に於ける脱硫の問題(第 1 報)
- 鐵及び満俺合金の X 線に依る定量分析