<Ogirinal>Tensile Shear Creep Test of Steel-Balsa-Steel Sandwich Panel as Floor Deck (I) : Stress Distribution and Deformation of Specimen
スポンサーリンク
概要
- 論文の詳細を見る
この論文は国立情報学研究所の学術雑誌公開支援事業により電子化されました。Stress analysis by finite element method of tensile shear test specimens of steel-balsa-steel sandwich panel for creep test was made statically. The stress distribution of five different shapes of sandwich panel specimens, two of them in accordance with ASTM-C-273, were analysed through the calculation of normal stress (σ_Y), maximum principal stress (σ_1), shear stress (τ_XY) and principal shear stress (τ_max). The presence of stress singularities at the reentrant corners made by specimen and loading plates suggests fracture occurance in balsa core near the corner. Stress intensity factors (KA) in balsa core near the corner were calculated under assumption of similarity with that in homogeneous body. The results obtained were as follows: 1) σ_Y, σ_1 and τ_max of balsa core concentrated near the reentrant corners, and τ_XY distribution was uniform throughout the balsa core, 2) Comparing K_A of various specimens it was suggested that the estimated fracture load on specimens shaped within the range specified by ASTM standard (length l/thickness t≧12) did not vary. Fracture load of specimens with l/t=8.2, 6.3 and 4.2 were lower than those of the standard specimens. Therefore, the standard shape will be utilized in the further investigation: tensile shear creep test of sandwich panel as floor deck (II).
- 京都大学の論文
- 1987-12-28
著者
-
Yang P
Kumamoto Univ.
-
Rezende M
National Institute Of Metrology Standardization And Industrial Quality-sas Qd.:wood Research Institu
-
Rezende Maria
National Institute Of Metrology Standardization And Industrial Quality-sas Qd.:wood Research Institu
-
Sasaki Hikaru
Wood Research Institute Kyoto University
-
YANG Ping
Wood Research Institute, Kyoto University
関連論文
- Tensile Shear Creep Test of Steel-Balsa-Steel Sandwich Panel as Floor Deck (II) : Development of Simple Shear Creep Test Machine
- Foundational Experimental Study on Compressive Wood : A Demonstration of Its Application for Woodworking Teaching
- Rheological Properties of Laminated Veneers During Hot-Pressing
- Physical Properties of Low-density Particleboard
- Molding Wood-based Composites II : Deformation and Stress Distribution during Mold-pressing
- Molding Wood-based Composites I : Mechanical and Dimensional Stability Properties
- Tensile Shear Creep Test of Steel-Balsa-Steel Sandwich Panel as Floor Deck (I) : Stress Distribution and Deformation of Specimen