Prevention of Fluorine Elution from Electric Arc Furnace Reducing Slag into Water
スポンサーリンク
概要
- 論文の詳細を見る
- 2011-03-15
著者
-
Miki Takahiro
Department Of Metallurgy Graduate School Of Engineering Tohoku University
-
Hino Mitsutaka
Tohoku Univ.
-
Nagaike Yuuki
Graduate School Of Engineering Tohoku University
-
MIKI Takahiro
Department of Hygiene Service, Himeji Livestock Hygiene Service Center, 2-10-16, Tadera-higashi, Himeji, Hyogo 670-0081, Japan
関連論文
- Numerical Analysis on Si Deoxidation of Molten Fe, Ni, Fe-Ni, Fe-Cr, Fe-Cr-Ni, Ni-Cu and Ni-Co Alloys by Quadratic Formalism
- Numerical Analysis on Si Deoxidation of Molten Fe-Ni and Ni-Co Alloys by Quadratic Formalism
- Elution Mechanism of Fluorine form Steelmaking Slag into Seawater
- Dissolution behavior of environmentally regulated elements from steelmaking slag into seawater
- Dissolution behavior of nutrition elements from steelmaking slag into seawater
- Activity Measurement of the Constituents in Molten Sn-Mg-Zn-Ternary Lead Free Solder Alloys by Mass Spectrometry
- Activity Measurement of Silicon in Molten Cu-Si Binary Alloy
- Activity Measurement of the Constituents in Molten Ag-In-Sn Ternary Alloy by Mass Spectrometry
- Activity Measurement of CaO-SiO_2-AlO_-MgO Slags Equilibrated with Molten Silicon Alloys
- Thermodynamic Properties of Si-Al,-Ca, -Mg Binary and Si-Ca-Al, -Ti, -Fe Ternary Alloys
- Sulphide Capacity and Sulphur Solubility in CaO-Al_2O_3 and CaO-Al_2O_3-CaF_2 Slags
- Aluminum Deoxidation Equilibrium of Molten Fe-Ni Alloy Coexisting with Alumina or Hercynite
- Magnesium Deoxidation Equilibrium of Molten Fe-Ni Alloy Expressed by Quadratic Formalism and Redlich-Kister Type Polynomial
- Ti Deoxidation Equilibrium in Molten Fe-Cr and Fe-Cr-Ni Alloys at Temperatures between 1823K and 1923K
- Ti Deoxidation Equilibrium in Molten Fe-Ni Alloys at Temperatures between 1823 to 1923K
- Identification of Titanium Oxide Phases Equilibrated with Liquid Fe-Ti Alloy Based on EBSD Analysis
- Carburization Degree of Iron Nugget Produced by Rapid Heating of Powdery Iron, Iron Oxide in Slag and Carbon Mixture
- Temperature Dependence of Ti Deoxidation Equilibria of Liquid Iron in Coexistence with 'Ti_3O_5' and Ti_2O_3
- Behavior of Ironmaking Slag Permeation to Carbonaceous Material Layer
- Equilibrium between Titanium and Oxygen in Liquid Fe-Ti Alloy Coexisted with Titanium Oxides at 1873K
- Numerical Analysis on Si Deoxidation of Molten Ni and Ni-Cu Alloy by Quadratic Formalism
- Effect of Fe3C on Carburization and Smelting Behavior of Reduced Iron in Blast Furnace
- Measurements of Thermodynamic Properties of Iron in Molten Silicon by Knudsen Effusion Method
- Dephosphorization Treatment of High Phosphorus Iron Ore by Pre-reduction, Mechanical Crushing and Screening Methods
- Prevention of Fluorine Elution from Electric Arc Furnace Reducing Slag into Water
- Dephosphorization Treatment of High Phosphorus Iron Ore by Pre-reduction, Air Jet Milling and Screening Methods
- Prevention of Chromium Elution from Stainless Steel Slag into Seawater
- Phase Equilibrium between CaO・Al_2O_3 Saturated Molten CaO-Al_2O_3-MnO and (Ca, Mn)S Solid Solution
- Investigation of Compositional Change of Inclusions in Martensitic Stainless Steel during Heat Treatment by Newly Developed Analysis Method
- Magnesium Deoxidation Equilibrium of Molten Fe-Cr-Ni Alloy Expressed by Quadratic Formalism and Redlich-Kister Type Polynomial
- Henhouse Feeding Style and Salmonella Enteritidis Contamination in Unvaccinated Flocks of Egg Farms, April 1994-March 2001
- Effect of Pre-melting Operation on the Vaporization Behavior of Phosphorus from Incinerator Ash of Sewage Sludge
- Effect of Al2O3 Refractories on Oxygen Content of Molten Fe–Cr Alloy
- Effect of Pre-melting Operation on the Vaporization Behavior of Phosphorus from Incinerator Ash of Sewage Sludge
- Recovery of Molybdenum from Spent Lubricant
- Recovery of Molybdenum from Copper Slags
- Effect of Al_2O_3 Refractories on Oxygen Content of Molten Fe-Cr Alloy