Steam Electrolysis Using LaGaO_3 Based Perovskite Electrolyte for Recovery of Unused Heat Energy
スポンサーリンク
概要
- 論文の詳細を見る
Application of LaGaO3 based electrolyte for steam electrolysis was studied for the useful utilization of unused heat energy from steelmaking process. It was found that the H2 formation rate almost obeys the Faradays law suggesting unity of oxide ion transport number in LaGaO3 perovskite under an electrolysis condition up to 2.0 V applied potential. Among the examined cathode catalyst, nickel shows the smallest cathodic overpotential and the addition of Fe to Ni is highly effective for increasing the H2 formation rate in the steam electrolysis at 873 K. The highest H2 formation rate is obtained at the composition of Ni : Fe = 9 : 1. Short stack of the steam electrolysis cell consisting of 25 cells in series connection was also studied and the formation rate of H2 was achieved as large as 70 L/min at 1.8 V applied potential. Heat balance was calculated based on the developed stack level. It became clear that the heat source of 223 K level is enough for sustaining cell temperature because of large Joule heat.
- 2010-09-15
著者
-
Ishihara Tatsumi
Department Of Applied Chemistry Faculty Of Engineering Kyushu University
-
KANNO Takao
Dennken Co. Ltd.
関連論文
- 遊星型ビーズミルを用いて調製したバリウムジルコネートの高焼結性
- Combustion Synthesis of Doped Lanthanum Gallate as an Electrolyte for Solid Oxide Fuel Cells
- The Effect of Zn Addition to La_Sr_xScO_ Systems as a B-site Dopant
- Honeycomb-type Solid Oxide Fuel Cells Using La_Sr_Ga_Mg_O_3 Electrolyte
- Stable and Active AlPO_4 Catalyst for Decomposition of CCl_2F_2
- Novel Catalysts Effective for Dehydrofluorination of CF_3CH_3(HFC143a)into CF_2CH_2
- Decomposition of Methane over Ni/SiO_2 Catalysts with Membrane Reactor for the Production of Hydrogen
- Adsorption of Water Vapor on Crystalline Phases of V-P-O
- Ion-Exchange Properties of Li Ion Conductor, LiTi_xZr_(PO_4)_3
- Direct Decomposition of NO on Cu-Doped La (Ba) Mn (In) O_3 Perovskite Oxide under Coexistence of O_2, H_2O, and SO_2
- Photocatalytic Decomposition of Pure Water over NiO Supported on KTa(M)O_3(M=Ti^, Hf^, Zr^)Perovskite Oxide
- Mixed Electronic-Oxide Ionic Conductivity and Oxygen Permeating Property in Ni Doped LaGaO_3 Perovskite Oxide
- Catalytic Decomposition of CF_4 over AIPO_4 - Based Catalysts
- Capacitive Type NO Sensor of CoO-In_2O_3 Distinguishable from NO_2
- Novel Catalysts for Oxidative Dehydrogenation of Iso-Butane to Iso-Butane
- Improvement of Sensing Characteristics of the Capacitive Type CO_2 Sensor, CuO-BaTiO_3, by Addition of Metal or Metal Oxide
- Selective Reduction of Nitrogen Monoxide with Propene over Cu-Silicoaluminophosphate (SAPO) under Oxidizing Atmosphere
- Preparation of Yttria-Stabilized Zirconia Films for Solid Oxide Fuel Cells by Electrophoretic Deposition Method
- Effects of Additives on the Activity of Palladium Catalysts for Methane Combustion
- Palladium Ion-exchanged SAPO-5 as a Catalyst for Low Temperature Combusion of Methane
- CH4分解により得たグラファイト炭素チューブのLiイオン2次電池の負極特性
- Development of New Fast Oxide Ion Conductor and Application for Intermediate Temperature Solid Oxide Fuel Cells
- Micro Solid Oxide Fuel Cell using Dimethyl Ether (DME) for Fuel
- Effects of Added CO_2 and H_2 on the Direct Decomposition of NO over BaMnO_3-Based Perovskite Oxide
- NO Decomposition on Ruddlesden-Popper-Type Oxide, Sr_3Fe_2O_7, Doped with Ba and Zr
- Direct Decomposition of NO into N_2 and O_2 on SrFe_Mg_O_3 Perovskite Oxide
- Steam Electrolysis Using LaGaO_3 Based Perovskite Electrolyte for Recovery of Unused Heat Energy
- Pd-Au Bimetal Supported on Rutile-TiO_2 for Selective Synthesis of Hydrogen Peroxide by Oxidation of H_2 with O_2 under Atmospheric Pressure
- Effects of Redox Potential of Metallophthalocyanine Dye on Photocatalytic Activity of KTa(Zr)O_3 for Water Splitting
- Development of Highly Reliable Gas Sensor for Detecting Gas Leakage and Fire
- Effects of Nitrogen Doping on Photocatalytic Water-splitting Activity of Pt/KTa_Zr_O_3 Perovskite Oxide Catalyst
- Single-nanosize pulverization of solid oxide by means of a wet planetary-bead-milling
- 空気極にPd修飾メソポーラスCoOを用いるLi-空気2次電池
- Single-nanosize pulverization of solid oxide by means of a wet planetary-bead-milling
- Development of Ni-Fe Based Cermet Anode for Direct CH4 Fueled Intermediate Temperature SOFC Using LaGaO3 Electrolyte
- Improvement of Photocatalytic Activity of Metal Sulfide by Organic Dye for H2 Formation from Water
- As-Deposited (La1-xSrx)(Ga1-y-zMgyCoz)O3-(x+y+z)/2 Crystallized Thin Films Prepared by Pulsed Laser Deposition for Application to Solid Oxide Fuel Cell Electrolyte
- Hydrogen-oxygen Generation with Intermediate Temperature Steam Electrolysis Using LaGaO_3 Based Perovskite Electrolyte for Recovery of Unused Heat Energy
- Effect of Dopants Pr and La on the Catalytic Activity of Cerium Oxide for Soot Oxidation