Influence of Mineral Matter on Carbon Dissolution from Metallurgical Coke into Molten Iron : Interfacial Phenomena
スポンサーリンク
概要
- 論文の詳細を見る
Identifying key factors governing the rate of carburisation of liquid iron is important for sustainable developments in blast furnace ironmaking. This study investigated the influence of mineral matter on carburisation rate ‘K’ for two different cokes: coke 1 (K=14.7×10−3 s−1) and coke 2 (K=1.1×10−3 s−1). The sessile drop technique was used to investigate carbon dissolution from coke into molten iron (1450°C, 1550°C) and the nature of interfacial products formed. Examination of the underside of the iron droplets showed the iron/coke interface was markedly different in appearance and composition between the two cokes. The interfacial product formed with coke 2 had a mesh like structure that seemed to wet the iron droplet much better than the interfacial product formed with coke 1. In contrast, Fe globules and discrete interfacial products were observed in coke 1. Interfacial products containing calcium sulfide (CaS) and manganese sulfide (MnS), were observed for both cokes. The presence of MnS could reduce the overall viscosity of the interfacial layer as its known to lower the liquidus temperature. Electron dispersive X-ray analyses of coke 1 identified iron to be in close association with sulfur. These Fe/S species have atomic ratio similar to pyrrhotite (Fe1−xS) or troilite (FeS). Pyrrhotite in coke can decompose to release gaseous sulfur and metallic iron, which can be carburised to form Fe–C particles. Carburisation of liquid iron can thus occur via Fe–C particles. These factors can have a significant influence on the kinetics of carbon dissolution.
- 2009-12-15
著者
-
Khanna Rita
Centre for Sustainable Materials Research and Technology, School of Materials Science and Engineerin
-
Sahajwalla Veena
Centre for Sustainable Materials Research and Technology, School of Materials Science and Engineerin
-
Cham S.
School of Materials Science and Engineering, The University of New South Wales
-
Sakurovs Richard
CSIRO Energy Technology
-
French David
CSIRO Energy Technology
-
Khanna Rita
Centre For Sustainable Materials Res. And Technol. School Of Materials Sci. And Engineering The Univ
-
Sakurovs Richard
Csiro
-
Cham S.
School Of Materials Science And Engineering The University Of New South Wales
-
Sahajwalla Veena
Centre For Sustainable Materials Research And Technology School Of Materials Science And Engineering
-
Khanna Rita
Centre For Sustainable Materials Research And Technology School Of Materials Science And Engineering
-
Sahajwalla Veena
Centre For Sustainable Materials Research And Technology (smart@unsw) School Of Materials Science An
関連論文
- High-temperature Interactions of Alumina–Carbon Refractories with Molten Iron
- Influence of Mineral Matter on Carbon Dissolution from Metallurgical Coke into Molten Iron: Interfacial Phenomena
- 高温NMRによる軟化溶融石炭の擬似成分ランピング解析(論文賞,平成17年度 日本エネルギー学会)
- 軟化溶融石炭の擬似成分ランピング解析
- 高温NMRによる軟化溶融石炭の擬似成分ランピング解析
- コバルト担持スメクタイトならびにコバルトモリブデン担持アルミナ系触媒共存下での石油由来アスファルテンの^1H-NMR熱分析
- コバルト担持スメクタイトならびにコバルトモリブデン担持アルミナ系触媒共存下での石油由来アスファルテンの^1H-NMR熱分析
- In-situ 1H-NMR Thermal Analysis Study for Reaction of Bituminous Coal with Sulfur
- In-situ Proton Magnetic Resonance Thermal Analysis for Mesophase Formation of Pitches
- リン酸水素カルシウムを捕集剤とするクロムの濃縮/誘導結合プラズマ発光分析法による水試料中のクロム(III)及びクロム(VI)の分別定量
- 8.石炭の高温NMR測定と軟化溶融状態
- Influence of Mineral Matter on Carbon Dissolution from Metallurgical Coke into Molten Iron : Interfacial Phenomena
- Carbon/Slag Interactions between Coke/Rubber Blends and EAF Slag at 1550℃
- Influence of Temperature on Carbon Dissolution of Cokes in Molten Iron
- Factors Influencing Carbon Dissolution from Cokes into Liquid Iron
- The Influence of Ash Impurities on Interfacial Reactions between Carbonaceous Materials and EAF Slag at 1550℃
- High-temperature Interactions of Alumina-Carbon Refractories with Molten Iron
- A Kinetic Study of Pyrolysis of a Brown Coal using High Temperature ^1H-NMR
- Carbon Dissolution Occurring during Graphite-Ferrosilicon Interactions at 1550℃
- Degradation Behaviour of a High CSR Coke in an Experimental Blast Furnace : Effect of Carbon Structure and Alkali Reactions
- Dynamic Wetting of Graphite and SiC by Ferrosilicon Alloys and Silicon at 1550℃
- Effect of Carbonisation Conditions on Mineral Matter in Coke
- Influence of Mineral Matter on Coke Reactivity with Carbon Dioxide
- Combustion of Agricultural Waste and Coke Blends during High Temperature Processes : Effect of Physical, Chemical and Surface Properties
- Reduction of FeO in EAF Steelmaking Slag by Metallurgical Coke and Waste Plastics Blends
- Structural Transformation of Agricultural Waste/Coke Blends and Their Implications during High Temperature Processes
- Chemical Interactions in Al2O3–C/Fe System at 1823 K: Implications for Refractory Recycling
- Recycling of end-of-life Melamine at 1600°C for Carbon Dissolution into Liquid Iron
- Recycling Waste Polymers in EAF Steelmaking : Influence of Polymer Composition on Carbon/Slag Interactions
- Recycling of end-of-life Melamine at 1600℃ for Carbon Dissolution into Liquid Iron
- SiC and Ferro-silicides Formation in Tuyere Cokes
- Carbothermic Reduction of Alumina at 1823K in the Presence of Molten Steel : a Sessile Drop Investigation
- Interfacial Reactions between Coke/HDPE Blends and High Carbon Ferromanganese Slag
- Chemical Interactions in Al_2O_3-C/Fe System at 1823K : Implications for Refractory Recycling
- SiC and Ferro-silicides Formation in Tuyere Cokes
- Interfacial Reactions between Coke/HDPE Blends and High Carbon Ferromanganese Slag
- Reduction Reactions in Al2O3–C–Fe and Al2O3–Fe2O3–C Systems at 1823 K