Molten Steel Flow Control under Electromagnetic Level Accelerator in Continuous Casting Mold
スポンサーリンク
概要
- 論文の詳細を見る
In a continuous casting process, magnetic coil has been applied to the molten steel flow control in a mold. Some of the magnetic coils are applied to stabilize the molten steel flow and the meniscus fluctuation to prevent powder entrapments. Others are applied to activate the molten steel flow to keep proper temperature at the meniscus or wash inclusions off near the solidification front. The Electromagnetic Level Accelerator (EMLA) has been developed to accelerate the molten steel flow from the nozzle in order to carry the molten steel to the narrow side of the mold when the casting speed is low or the mold width is wide. It applies low frequency alternating magnetic field moving from the nozzle to the narrow side of the mold just below the nozzle exits, because the electromagnetic force acts on the molten steel in the same direction as the magnetic field moving. In this study, the effect of the EMLA on the molten steel flow is investigated. Numerical simulation of the molten steel flow was carried out. The molten steel flow velocity measurement was also conducted in operation.Applying the EMLA, the molten steel flow is accelerated proportional to the imposed magnetic field. The molten steel flow from the nozzle can be controlled to reach the narrow side of the mold. Therefore, the risk of the extraordinary temperature drop at the mold corner of the meniscus decreases and the capture of the inclusions into the solidification shell that causes the surface defects is avoidable.
- 社団法人 日本鉄鋼協会の論文
- 2007-07-15
著者
-
ISHII Toshio
JFE R&D Corporation
-
Ishii T
Jfe R&d Corp.
-
Ishii Toshio
Jfe R&d Corporation
-
SUZUKI Makoto
JFE Steel Corporation
-
Kubota Jun
Jfe Steel Corp.
-
KUBO Noriko
JFE R&D Corp.
-
Kubo N
Jfe R&d Corp.
-
Suzuki Makoto
Jfe Steel Corp.
-
KUBO Noriko
JFE R&D Corp.
-
ISHII Toshio
JFE R&D Corp.
関連論文
- Swirl motion of a water jet in a water bath of linearly increasing depth (特集 流動の可視化)
- Behavior of a Droplet on an Inclined Plate under Various Wettability Conditions
- Occurrence Process of Jet-Induced Rotary Sloshing in a Cylindrical Container
- Numerical Simulation on a Horizontal Flow Pattern of Jet-induced Rotary Sloshing in a Cylindrical Container
- A bouncing droplet on an inclined hydrophobic surface
- Effect of Properties of Mold Powder Entrapped into Molten Steel in a Continuous Casting Process
- Molten Steel Flow Control under Electromagnetic Level Accelerator in Continuous Casting Mold
- Numerical Simulation of Molten Steel Flow under a Magnetic Field with Argon Gas Bubbling in a Continuous Casting Mold
- Two-phase Flow Numerical Simulation of Molten Steel and Argon Gas in a Continuous Casting Mold
- Simulation of Sliding Nozzle Gate Movements for Steel Continuous Casting
- Mathematical Modeling of Flow and Inclusion Motion in Vessel with Natural Convection
- The Steel Flow Control System in Caster Mold by Traveling Magnetic Field