Power Saving Control for Battery-Powered Portable WLAN APs
スポンサーリンク
概要
- 論文の詳細を見る
This paper proposes a power saving control function for battery-powered portable wireless LAN (WLAN) access points (APs) to extend the battery life. The IEEE802.11 standard does not support power saving control for APs. To enable a sleep state for an AP, the AP forces the stations (STAs) to refrain from transmitting frames using the network allocation vector (NAV) while the AP is sleeping. Thus the sleep state for the AP can be employed without causing frame loss at the STAs. Numerical analysis and computer simulation reveal that the newly proposed control technique conserves power compared to the conventional control.
- 2009-09-01
著者
-
OGAWA Masakatsu
NTT Access Network Service Systems Laboratories, NTT Corporation
-
HIRAGURI Takefumi
NTT Access Network Service Systems Laboratories, NTT Corporation
-
Ogawa Masakatsu
Ntt Access Network Service Systems Laboratories Ntt Corporation
-
Hiraguri Takefumi
Ntt Access Network Service Systems Laboratories Ntt Corporation
関連論文
- Proposal and Evaluation of a Mesh Wireless Local Area Network Architecture with Dual DCF-HCCA Channel Access Scheme in the Vicinity of Gateway Access Points(Mobile Multimedia Communications)
- B-5-153 Increasing Throughput of Multi-channel Mesh Networks through Polling and Multi CTS Transmission around Gateway APs
- Power Saving Scheme Suitable for Wireless LAN in Multimedia Communications
- Proposal of Wireless Traffic Control Schemes for Wireless LANs
- Power Saving Control for Battery-Powered Portable WLAN APs
- Novel Multiple Access Protocol for Voice over IP in Wireless LAN(Special Issue on Mobile Multimedia Communications)