Hysteresis Loop for a No-loaded, Delta-connected Transformer Model Deduced from Measurements

概要

論文の詳細を見る
At a transformers steady-state condition, whereby a transformer and its load are constantly supplied by a sinusoidal source, the current-flux pair within the transformer core and its windings will cycle along a hysteresis loop. This nonlinear current-flux characteristic becomes important while at transformer gets reenergized. A remaining residual flux and the fact that a transformer is typically used up to its saturation level can lead to high-amplitude magnetizing inrush currents and associated voltage disturbances. These disturbances can be reduced by controlled transformer switching. In order to pre-evaluate the effect of a specific controlled transformer energization, pre-simulations can be applied. In that case the hysteresis loop and its saturation characteristic will become the most important model parameter. If the corresponding manufacturer specifications are not available a standard hysteresis loops can be used, but might come up with an inaccurate simulation result. Therefore, this paper analyses the measured 3-phase currents from two delta-connected power transformers by “Fourier Series” in order to deduce a single-phase hysteresis loop, which can be implemented into a typical 3-phase transformer model. Additionally, the saturation behavior of a power-transformer will be estimated and a comparison of ATP/EMTP simulations will conclude this paper.
2010-02-01