Removal of Sn(4) ions by galvanostatic electrolysis from Aqueous hydrochloric solution containing Sn(4) and In(3) (第6回資源リサイクル・材料科学に関する日韓国際シンポジウム特集号)
スポンサーリンク
概要
- 論文の詳細を見る
In order to develop a hydrometallurgical recycling process for an indium-tin-oxide (ITO) target, it is necessary to remove Sn(IV) ions from solutions containing Sn(IV) and In(III). In this study, therefore, the removal of Sn(IV) ions by galvanostatic electrolysis was examined. Polarization measurements were carried out under a nitrogen atmosphere. In the Sn(IV) solution, the current begins to increase at a cathode potential of −0.26 V vs. SHE, and keeps on increasing with a negative shift of the cathode potential. In the In(III) solution, the current begins to increase at a cathode potential of −0.43 V vs. SHE. In the galvanostatic electrolysis, 52% of Sn(IV) ions were removed and electrodeposited as metallic tin containing less than 1% indium; the current efficiency was close to 100%. After further electrolysis, indium was codeposited with tin.
- 環境資源工学会の論文
- 2009-09-10
著者
-
Koyama Kazuya
Metals Recycling Group Res. Inst. For Environmental Management Technol. National Inst. Of Advanced I
-
Koyama Kazuya
Metals Recycling Group Research Institute For Environmental Management Technology National Institute
-
TANAKA Mikiya
Metals Recycling Group, Research Institute for Environmental Management Technology, National Institu
-
FUJIWARA Shinji
Sumitomo Chemical Co., Ltd.
-
SAEGUSA Kunio
Sumitomo Chemical Co., Ltd.
-
Saegusa Kunio
Sumitomo Chemical Co. Ltd.
-
Tanaka Mikiya
Metals Recycling Group Res. Inst. For Environmental Management Technol. National Inst. Of Advanced I
-
Tanaka Mikiya
Metals Recycling Group Research Institute For Environmental Management Technology National Institute
-
Fujiwara Shinji
Sumitomo Chemical Co. Ltd.
関連論文
- Removal of Sn(4) ions by galvanostatic electrolysis from Aqueous hydrochloric solution containing Sn(4) and In(3) (第6回資源リサイクル・材料科学に関する日韓国際シンポジウム特集号)
- Influence of Electrolyte on an Energy-Saving Copper Recycling Process Using Ammoniacal Alkaline Solutions
- Electrolytic Copper Deposition from Ammoniacal Alkaline Solution Containing Cu(I)
- Copper Leaching Behavior from Waste Printed Circuit Board in Ammoniacal Alkaline Solution
- Rapid Separation of Palladium(II) from Platinum(IV) in Hydrochloric Acid Solution with Thiodiglycolamide