A Series Type BTB Converter for Controlling Voltage Profile in Loop Distribution System with Distributed Generations
スポンサーリンク
概要
- 論文の詳細を見る
Connecting Distributed Generations (DGs) into distribution system has presented challenge of controlling voltage profile in distribution system. The presence of DGs makes voltage profile non-uniform and may result in large voltage fluctuation and over-voltage at loads. Therefore, there is need for strict limitation on power injected by DGs. This paper proposes an effective method to overcome the problem of increase/decrease of voltage in distribution system due to the presence of DGs, and it also realizes higher permissible power injected by DGs. In the proposed method, the configuration of distribution system is changed, firstly, from radial to loop type by tying the receiving ends of feeders. Secondly, a series type Back-To-Back (BTB) converter is installed near substation to improve voltage profile by controlling the voltages of the two nodes in the looped feeders. The effectiveness of the proposed method for improvement of the voltage profile and reduction of the converter capacity is presented.
- 社団法人 電気学会の論文
- 2008-05-01
著者
-
MIURA Yushi
Division of Electric, Electronic and Information Eng., Graduate School of Eng., Osaka University
-
Miura Yushi
Division Of Electrical Electronic And Information Eng. Graduate School Of Eng. Osaka University
-
ISE Toshifumi
Division of Electric, Electronic and Information Engineering, Graduate School of Engineering, Osaka
-
SIMANJORANG Rejeki
Division of Electrical, Electronic and Information Eng., Graduate School of Eng., Osaka University
-
Ise Toshifumi
Division Of Electric Electronic And Information Eng. Graduate School Of Eng. Osaka University
-
Ise Toshifumi
Division Of Electrical Electronic And Information Eng. Graduate School Of Eng. Osaka University
-
Rejeki Simanjorang
Division Of Electrical Electronic And Information Eng. Graduate School Of Eng. Osaka University
-
Simanjorang Rejeki
Division Of Electrical Electronic And Information Eng. Graduate School Of Eng. Osaka University
関連論文
- Power Hardware-in-the-loop Simulation of a Gas Engine Cogeneration System for Developing a Power Converter System
- Stability and Accuracy Analysis of Power Hardware-in-the-loop Simulation of Inductor Coupled Systems
- Real Time Simulation of a Gas Engine Cogeneration System with a Matrix Converter
- Distributed-Series Compensator for Controlling Voltage in Distribution Line with Clustered Distributed Generations
- A Series Type BTB Converter for Controlling Voltage Profile in Loop Distribution System with Distributed Generations
- Distributed Series Compensators for Controlling Voltage Profile in Distribution Line with Distributed Generations
- A Method for Effective Utilization of Power Distribution Apparatus in Industrial Park by Looping Distribution Lines
- Current Injection Control Scheme of Voltage Sag Compensation by Parallel Type Compensator with Series Inductor
- Loop Power Balancer System between Distribution Power Transformers Using a Small Capacity Series Type Back to Back Converter
- Series Type Back to Back Converter for Power Exchanging Between Transmission and Distribution Lines
- Standby Mode Operation of Series Type SMES for Voltage Sag Compensation (特集:平成17年〔電気学会〕電力・エネルギー部門大会)
- Transformer-Less Series Voltage Sag Compensator without Energy Storage Capacitor for Three-Phase Three-Line Systems
- Series Voltage Sag Compensation Using Series Type SMES with Open-Circuit Protection
- Series Voltage Sag Compensation Using Series Type SMES with Open-Circuit Protection
- Voltage Sag Compensation by Parallel Type Compensator and Series Inductor
- Application of VSC-HVDC with Shunt Connected SMES for Compensation of Power Fluctuation
- Power System Stabilization Control by HVDC with SMES Using Virtual Synchronous Generator