Irradiation Creep-Swelling Interaction in Modified 316 Stainless Steel up to 200dpa
スポンサーリンク
概要
- 論文の詳細を見る
The irradiation creep–swelling interaction parameters were precisely derived for MONJU fuel pin cladding PNC316 by irradiation tests of pressurized tubes in FFTF. It was found out that a creep–swelling coupling coefficient decreased and asymptotically approached a constant value as the swelling progresses, although it was widely believed that the irradiation creep rate could be proportional to the swelling rate. This non-proportionality in the irradiation creep–swelling interaction was investigated by means of the rate theory analyses under sequential climb-controlled glide process of dislocation due to absorption of interstitial atoms. It was clarified through a constructed robust model that the presence of a precipitate sink should upset the proportionality of the net interstitial flux into dislocations to the net vacancy flux into the voids. In addition, irradiation creep parameters derived by material irradiation was demonstrated to be applicable for reasonably predicting the irradiation creep deformation in the fuel pins.
- 一般社団法人 日本原子力学会の論文
- 2007-05-25
著者
-
Ukai Shigeharu
Hokkaido University
-
Ukai Shigeharu
Div. Of Materials Sci. And Engineering Graduate School Of Engineering Hokkaido Univ.
-
OHTSUKA Satoshi
Japan Atomic Energy Agency
関連論文
- High Burnup Fuel Cladding Materials R&D for Advanced Nuclear Systems : Nano-sized oxide dispersion strengthening steels
- Effects of Zr Addition on the Microstructure of 14%Cr4%Al ODS Ferritic Steels
- Characterization of Mechanically Alloyed Powders for High-Cr Oxide Dispersion Strengthened Ferritic Steel
- Mechanical Behavior of Oxide Dispersion Strengthened Steels Irradiated in JOYO
- Water Corrosion Resistance of ODS Ferritic-Martensitic Steel Tubes
- Development of Manufacturing Process of PNC-FMS Wrapper Tube with SUS316 Short Joint
- Improvement of Creep Strength of 9CrODS Martensitic Steel by Controlling Excess Oxygen and Titanium Concentrations
- Development of Two-Step Softening Heat Treatment for Manufacturing 12Cr-ODS Ferritic Steel Tubes
- Production and Properties of Nano-scale Oxide Dispersion Strengthened (ODS) 9Cr Martensitic Steel Claddings
- Kinetic Approach for Growth and Coalescence of Nano-Size Oxide Particles in 9Cr-ODS Steel Using High-Energy Synchrotron Radiation X-rays in SPring-8
- Refinement of Oxide Particles by Addition of Hf in Ni-0.5 mass% Al-1 mass% Y_2O_3 Alloys
- Irradiation Creep-Swelling Interaction in Modified 316 Stainless Steel up to 200dpa
- Grain Boundary Deformation at High Temperature Tensile Tests in ODS Ferritic Steel
- Recrystallization Texture of Cold-rolled Oxide Dispersion Strengthened Ferritic Steel