In-pile Experiment in JMTR on the Radiation Induced Surface Activation (RISA) Effect on Flow-boiling Heat Transfer

概要

論文の詳細を見る
In-pile flow-boiling experiments were performed to investigate the possible enhancement of heat transfer by the radiation induced surface activation (RISA) effect. The test section was a 2-mm diameter 100-mm long bore in a SUS-316L stainless steel block heated electrically. The test section, housed in an irradiation capsule, was inserted into one of the irradiation holes in the Japan Materials Testing Reactor (JMTR) of the Japan Atomic Energy Agency (JAEA). Quasi-steady state experiments were conducted before irradiation (out-of-pile and in-pile before reactor operation), during irradiation and after irradiation (in-pile), for the same boundary conditions using the same test section block. This approach allowed direct evaluation of the RISA effect through comparison of experimental data. Boiling curves were obtained up to the onset of dryout in an annular dispersed flow, for mass fluxes ranging from 180 to 630 kg/(m2s) under a fixed pressure of 420 kPa. The critical heat flux obtained during and after irradiation indicated an about 17% increase, on average, from that before irradiation. Meanwhile, the wall superheat at subcritical heat fluxes generally became greater than that before irradiation.
社団法人日本原子力学会の論文
2007-02-25