Advanced Doped UO_2 Pellets in LWR Applications

概要

論文の詳細を見る
The nuclear industry strives to reduce the fuel cycle cost, enhance flexibility and improve the reliability of operation. This can be done by both increasing the fuel weight and optimizing rod internal properties that affect operational margins. Further, there is focus on reducing the consequences of fuel failures. To meet these demands Westinghouse has developed ADOPT (Advanced Doped Pellet Technology) UO2 fuel containing additions of chromium and aluminium oxides. This paper presents results from the extensive investigation program which covered examinations of doped and reference standard pellets both in the manufactured and irradiated states.The additives facilitate pellet densification during sintering and enlarge the pellet grain size. The final manufactured doped pellets reach about 0.5% higher density within a shorter sintering time and a five fold larger grain size compared with standard UO2 fuel pellets. The physical properties of the pellets, including heat capacity, thermal expansion coefficient, melting temperature, thermal diffusivity, have been investigated and differences between the doped and standard UO2 pellets are small.The in-reactor performance of the ADOPT pellets has been investigated in pool-side and hotcell Post Irradiation Examinations (PIEs), as well as in the Studsvik R2 test reactor. The investigations have identified three areas of improved operational behaviour: Reduced fission gas release, improved PCI performance thanks to increased pellet plasticity and higher resistance against post-failure degradation. Fuel segments have been exposed to ramp tests and enhanced power steady-state operation in the Studsvik R2 reactor after base-irradiation to above 30 MWd/kgU in a commercial BWR. ADOPT reveals up to 50% lower fission gas release than standard UO2 pellets. The fuel degradation behaviour has been studied in two oxidizing tests, a thermal-microbalance test and an erosion test under irradiation. The tests show that ADOPT pellets have a reduced rate of fuel washout, as compared to standard UO2 pellets.Fuel rods with ADOPT pellets have been irradiated in several light water reactors (LWRs) since 1999, including two full SVEA-96 Optima2 reloads in 2005.
2006-09-25

Advanced Doped UO_2 Pellets in LWR Applications

スポンサーリンク

概要

著者

関連論文

スポンサーリンク