Thermal Shock Analysis of Functionally Graded Materials by Micromechanical Model(Computational Mechanics)
スポンサーリンク
概要
- 論文の詳細を見る
The transient thermoelastic behavior of the functionally graded plate due to a thermal shock with temperature dependent properties is studied in this paper. The development of a micromechanical model for the functionally graded materials is presented and its application to thermoelastic analysis is discussed for the case of the W-Cu functionally graded material for the International Thermonuclear Experimental Reactor divertor plate. The divertor plate is made of a graded layer bonded between a homogeneous substrate and a homogeneous coating, and it is subjected to a cycle of heating and cooling on the coating surface of the material. The thermal and elastic properties of the material are dependent on the temperature and the Position. Numerical calculations are carried out, and the results for the transient temperature and thermal stress distributions are displayed graphically.
- 2002-04-15
著者
-
Ueda Sei
Department Of Mechanical Engineering Faculty Of Engineering Osaka Institute Of Technology
-
Ueda Sei
Department Of Mechanical Engineering Osaka Institute Of Technology
関連論文
- The Surface Crack Problem for a Layered Elastic Medium with a Functionally Graded Nonhomogeneous Interface(Fracture Mechanics)
- Thermal Shock Analysis of Functionally Graded Materials by Micromechanical Model(Computational Mechanics)
- Evaluation of Ferroelectric Properties of Piezoelectric Ceramics Based on Crystallographic Homogenization Method and Crystal Orientation Analysis by SEM・EBSD Technique
- A Study on Bio-Compatible Piezoelectric Materials by First Principles Calculation
- Dynamic Singular Stresses in Cracked Glass-Fiber Reinforced Plastics at Low Temperatures
- Thermal Mechanical Response of Elastic Half-Plane with Infinite Row of Parallel Cracks under Uniform Heat Flux
- Identification of Material Properties of PZT Single Crystals through Crystallographic Homogenization Method