Nucleation of Proeutectoid Ferrite on Complex Precipitates in Austenite
スポンサーリンク
概要
- 論文の詳細を見る
Effect of various intragranular inclusions or precipitates (MnS, VC and V(C, N)) on the microstructure and kinetics of intragranular ferrite transformation at the temperatures between 973 and 823 K was studied using various Fe-2Mn-(0.13, 0.2)C(mass%) alloys with the small addition of sulfur, vanadium, and nitrogen. In Fe-2Mn-0.13C-50ppmS and Fe-2Mn-0.2C-470ppmS alloys, MnS particles, mostly incoherent in austenite, do not act as effective nucleation sites of ferrite. V addition slightly improves the potency of MnS as ferrite nucleation site by forming MnS+VC complex precipitates. The addition of both V and N largely enhances the intragranular nucleation of ferrite idiomorph on the MnS+V(C, N) complex precipitate. It is considered that two factors, i.e., (1) the advantage in the balance of interphase boundary energy and (2) the increase in the fraction of V(C, N) precipitate by the addition of nitrogen, are mainly responsible for the promotion of intragranular ferrite formation on the MnS+V(C, N) complex precipitate.
- 社団法人 日本鉄鋼協会の論文
- 2003-10-15
著者
-
MAKI T.
Department of Materials Science and Engineering, Kyoto University
-
Furuhara T.
Department Of Materials Science And Engineering Kyoto University
-
Miyamoto G.
Kyoto Univ.
-
FURUHARA T.
Institute for Materials Research, Tohoku University
-
MAKI T.
Kyoto University
-
Furuhara T
Institute For Materials Research Tohoku University
-
YAMAGUCHI J.
Kyoto University
-
SUGITA N.
Kyoto University
-
Furuhara T.
Department Of Material Science And Engineering Kyoto University
-
Maki T
Kyoto University
-
Sugita N
Kyoto University
関連論文
- Effect of carbon content on ausformed bainite structure in Fe-Ni-C alloys
- Microstructure of plasma nitrided Fe-Cr alloys
- Effect of Austenite Grain Size on the Morphology and Crystallography of Lath Martensite in Low Carbon Steels
- Microstructure of plasma nitrided ferritic stainless steel
- The thermodynamical effect of third alloying elements on cementite precipitation in tempered martensite
- Effect of third alloying element on precipitation of iron carbide in tempering of high carbon martensite
- Phase Transformation from Fine-grained Austenite
- Effect of Carbide Precipitation at Austenite Grain Boundary on Crystallography of Grain Boundary Ferrite
- Effect of transformation temperature and C content on the crystallographic feature of upper bainite
- Comparison of the dislocation substructure between the cold-rolled lath martensite and equiaxed ferrite in IF steel
- Multiphase Crystallography in the Nucleation of Intragranular Ferrite on MnS+V(C, N) Complex Precipitate in Austenite
- Nucleation of Proeutectoid Ferrite on Complex Precipitates in Austenite
- Precipitation in a plasma nitrided Fe-Ti alloy
- Kinetics and Crystallography of Intragranular Pearlite Transformation Nucleated at (MnS+VC) Complex Precipitates in Hypereutectoid Fe-Mn-C Alloys
- Grain Size of Proeutectoid Ferrite Transformed from Fine Grained Austenite in Fe-1.5Mn-0.2C Alloys
- Deformation Microstructure and Tensile Strength of Cold Rolled Pearlitic Steel Sheets
- Crystallography of Intragranular Pearlite Nucleated at (MnS+VC) Complex Precipitate in Austenite
- Effect of Mn and Si Addition on Microstructure and Tensile Properties of Cold-rolled and Annealed Pearlite in Eutectoid Fe-C Alloys
- Effect of ausforming on bainite structure in an Fe-Ni-C alloy
- Control of Cementite Precipitation in Lath Martensite by Rapid Heating and Tempering
- Ultra-fine (α+θ) Duplex Structure Formed by Cold Rolling and Annealing of Pearlite
- Effect of Initial Structure on Microstructure Change during Cold Rolling in an Ultra-low Carbon Steel
- Dislocation Density within Lath Martensite in Fe-C and Fe-Ni Alloys
- Effect of Carbon and Nickel Contents on Dislocation Structure in Ferrous Lath Martensite
- Special Issue on Ultrafine Grained Structures
- Austenite Grain Refinement by Repeated Cycles of Austenitizing and Quenching