Static and Metadynamic Recrystallization of Interstitial Free Steels during Hot Deformation
スポンサーリンク
概要
- 論文の詳細を見る
A rapid method was used to identify kinetics of the recrystallization for two IF (Interstitial Free) steels which have different phosphorous and boron contents. The static and metadynamic softening behaviour of the materials for a range of strain rates and temperatures were quantified. The critical strain for initiation of strain independent softening was estimated for the IF steels in respect to the time for 50 percent softening after deformation. The results showed that the strain for the initiation of strain independent softening (often referred to as metadynamic recrystallization) varies with the Zener Hollomon parameter. Classic static recrystallization was observed at strains below the strain independent softening for all processing conditions and the strain rate had a strong effect on the time for strain independent softening. Results also revealed that static and metadynamic recrystallization was delayed owing to the phosphorous and boron alloying elements. Hence, the large strain at above no-recrystallization temperature may be required for the early stage of Finishing Stands Unit (FSU) in hot strip rolling mills to initiate austenite grain refinement of phosphorous and boron added IF steels.
- 社団法人 日本鉄鋼協会の論文
- 2004-11-15
著者
-
Lee Youngseog
Department Of Mechanical Engineering Chung-ang University
-
Hodgson Peter
School Of Engineering And Technology Deakin University
-
Byon Sang
Rolling Technology And Process Control Research Group Posco Technical Research Laboratories
-
Zahiri Saden
School Of Engineering And Technology Deakin University
-
KIM Sung-II
Automotive Steel Products Research Group, POSCO Technical Research Laboratories
-
Kim Sung-ii
Automotive Steel Products Research Group Posco Technical Research Laboratories
関連論文
- Influence of the Geometry of an Immersed Steel Workpiece on Mass Transfer Coefficient in a Chemical Heat Treatment Fluidised Bed
- Experimental and Semi-analytical Study of Wear Contour of Roll Groove and Its Applications to Rod Mill
- An Approximate Model for Local Strain Variation over Material Thickness and Its Applications to Thick Plate Rolling Process
- The Effect of Chemistry on the Formation of Ultrafine Ferrite in Steel
- An Analysis of the Transition between Strain Dependent and Independent Softening in Austenite
- Static and Metadynamic Recrystallization of Interstitial Free Steels during Hot Deformation
- Formation of Ultrafine Grained Structure in Plain Carbon Steels Through Thermomechanical Processing
- Effect of the Roll Surface Profile on Centerline Segregation in Soft Reduction Process