Splashing and Spitting Behaviour in the Combined Blown Steelmaking Converter
スポンサーリンク
概要
- 論文の詳細を見る
The amount of iron droplets ejected in the BOF affects on metallic yield, refactory wear and the progress of decarburisation. The purpose of this study was to investigate the effect of lance height, lance nozzle angle, lance position, top gas flow rate, bottom blowing and foamy slag on splashing and spitting. A new cold model method for investigating the effects of above-mentioned parameters on the location and quantity of liquid splashed on the walls of the model was utilised. According to the model tests, reduction of the nozzle angle increased the total amount of splashing and spitting considerably. Consequently, reduced productivity due to an increase in metal losses, skulling of the cone and converter mouth and further increased time for skull removal is expected. Introduction of bottom blowing increased splashing significantly on lower parts of the vessel. Lance position has an effect on total amount of splashing when bottom blowing is used. The presence of even minor foam layer on water surface reduced the amount of total splashing significantly.
- 社団法人 日本鉄鋼協会の論文
- 2002-09-15
著者
-
Haerkki J
Laboratory Of Process Metallurgy University Of Oulu
-
Harkki Jouko
Laboratory Of Process Metallurgy Department Of Environmental And Process Engineering
-
Siivola Tero
Laboratory Of Process Metallugy University Of Oulu
-
Luomala Matti
Laboratory Of Process Metallugy University Of Oulu
-
Fabritius Timo
Laboratory Of Process Metallugy University Of Oulu
-
VIRTANEN Esa
Laboratory of Process Metallugy, University of Oulu
-
Virtanen Esa
Laboratory Of Process Metallugy University Of Oulu
関連論文
- Surface Tension of Liquid Fe-N-O-S Alloy
- The Modeling of the Gas Flow and Its Influence on the Scale Accumulation in the Steel Slab Pusher-type Reheating Furnace
- Physical Model Study of Selective Slag Splashing in the BOF
- Interfacial Phenomena in Metal-Slag-Gas System during AOD Process
- Behavior of Nitrogen During AOD Process
- The Effect of Bottom Nozzle Configuration on the Bath Behaviour in the BOF
- Splashing and Spitting Behaviour in the Combined Blown Steelmaking Converter
- Degradation of Iron Oxide Caused by Alumina during Reduction from Magnetite
- Effect of Reactive Gas on the Wetting of Molten Iron-Carbon Alloy on Ceramic Substrates
- CFD Model for Emulsification of Slag into the Steel
- Effect of Fluid Physical Properties on the Emulsification
- Occurrence and Composition of Some Mineral Phases in the Tuyere Coke
- A Mathematical Model for the Reduction Stage of the AOD Process. Part I: Derivation of the Model
- A Mathematical Model for the Reduction Stage of the AOD Process. Part II: Model Validation and Results
- Effect of H_2-H_2O on the Reduction of Olivine Pellets in CO-CO_2 Gas
- A Mathematical Model for the Reduction Stage of the AOD Process : Part II : Model Validation and Results