Cube Texture Development in an Al-Mg-Mn Alloy Sheet Worked by Continuous Cyclic Bending
スポンサーリンク
概要
- 論文の詳細を見る
- Japan Institute of Metalsの論文
- 2001-10-20
著者
-
TAKAYAMA Yoshimasa
Department of Mechanical Systems Engineering, Utsunomiya University
-
Szpunar J
Mcgill Univ. Quebec Can
-
Takayama Yoshimasa
Department Of Mechanical Systems Engineering Utsunomiya University
関連論文
- PREFACE
- Microstructure Refinement and Texture Evolution of Titanium by Friction Roll Surface Processing
- Microstructural and Textural Evolution by Continuous Cyclic Bending and Annealing in a High Purity Titanium
- Improvement of Fatigue Properties by Means of Continuous Cyclic Bending and Annealing in an Al-Mg-Mn Alloy Sheet
- Deformation and Fracture at High Temperatures in an Al-Mg-Mn Alloy Sheet Consisting of Coarse- and Fine-Grained Layers
- Crystallographic Orientation Distribution Control by Means of Continuous Cyclic Bending in a Pure Aluminum Sheet
- Preferential Growth of Cube-Oriented Grains in Partially Annealed and Additionally Rolled Aluminum Foils for Capacitors
- Prediction of Microstructural Evolution during Grain Growth of a Pure Aluminum by means of Monte Carlo Simulation
- Change in Crystallographic Orientation Distribution during High Temperature Deformation in an Al-Mg-Mn Alloy Sheet Consisting of Coarse- and Fine-Grained Layers
- Effect of Surface Microstructure of Titanium Sheet on the Photocatalytic Activity of Its Oxide Film
- Stored Energy and Taylor Factor Relation in an Al-Mg-Mn Alloy Sheet Worked by Continuous Cyclic Bending
- Cube Texture Development in an Al-Mg-Mn Alloy Sheet Worked by Continuous Cyclic Bending