Precipitation Kinetics and Strengthening of a Fe-0.8wt%Cu Alloy

スポンサーリンク

概要

• 論文の詳細を見る

• Precipitation kinetics and strengthening have been investigated for a Fe–0.8wt%Cu alloy. Microstructure evolution during aging at 500°C has been studied by a combination of Transmission Electron Microscopy and Small-Angle X-ray Scattering to provide information on the nature and location of the precipitates as well as a quantitative estimate of their size and volume fraction. The associated mechanical properties have been studied by hardness and tensile tests.The precipitation kinetics measured in this study are fully compatible with results reported for alloys with higher Cu levels. Nucleation of Cu precipitates is promoted by the presence of dislocations whereas coarsening rates in the later stages of aging appear to be not affected by fast diffusion paths along dislocations.The strength of individual precipitates increases with precipitate size based on the analysis of the mechanical test results. However, the strength of the largest precipitates observed remains approximately half of the strength required for the Orowan by-passing mechanism. The Russell-Brown model for modulus strengthening has successfully been applied to the current data.Study of the plastic behavior shows that the maximum initial hardening rate is related to the highest strength of the material. This unusual result may be explained by a dynamic strained-induced phase transformation of the precipitates from the bcc to the 9R structure. Consequently, the hardening potential of Fe–Cu alloys is associated with good plastic properties close to peak strength thereby indicating the excellent potential of copper as hardening element for the development of novel high strength interstitial free (IF) steels.

• 社団法人 日本鉄鋼協会の論文
• 2001-02-15

著者

• Deschamps A.

  Ltpcm/enseeg Umr5614 Domaine Universitaire De Grenoble

• Militzer M

  The Centre For Metallurgical Process Engineering The University Of British Columbia

• Militzer M.

  The Centre For Metallurgical Process Engineering The University Of British Columbia

• POOLE W.

  The Centre for Metallurgical Process Engineering, University of British Columbia

• Poole W.

  The Centre For Metallurgical Process Engineering The University Of British Columbia

関連論文

• Comparison of Precipitation Kinetics and Strengthening in an Fe-0.8%Cu Alloy and a 0.8%Cu-containing Low-carbon Steel
• Precipitation Kinetics and Strengthening of a Fe-0.8wt%Cu Alloy
• General Method of Phase Transformation Modeling in Advanced High Strength Steels
• Analysis of the Austenite Grain Size Distribution in Plain Carbon Steels

スポンサーリンク