Step Aging of a Sintered Ti-13mass%Cr β Alloy
スポンサーリンク
概要
著者
-
Takaki Setsuo
Department of Materials Science and Engineering, Kyushu University
-
IKEDA Yasuyuki
Department of Pharmacology, National Cardiovascular Center Research Institute
-
Takaki S
Kyushu Univ. Fukuoka‐ken Jpn
-
Takaki Setsuo
Department Of Material Science And Engineering Kyushu University
-
Ikeda Yasuyuki
Department Of Materials Science And Engineering Faculty Of Engineering Kyushu University
-
SUGAYA Kouji
Department of Materials Science and Engineering, Faculty of Engineering, Kyushu University
-
Sugaya Kouji
Department Of Materials Science And Engineering Faculty Of Engineering Kyushu University
関連論文
- Temperature Dependence of Austenite Nucleation Behavior from Lath Martensite
- Microstructure and Mechanical Properties in Ultra Fine-grained Oxide-dispersion Ferritic Stainless Steel
- Genotyping of the Human Lipoprotein Lipase Gene by Ferrocenylnaphthalene Diimide-based Electrochemical Hybridization Assay
- Direct Detection of Single Nucleotide Polymorphism (SNP) with Genomic DNA by the Ferrocenylnaphthalene Diimide-based Electrochemical Hybridization Assay (FND-EHA)
- Characterization of Submicron Ultrafine Grained Steel and Its Application
- Liposome Immobilization on Peptide-modified Quartz Crystal Microbalance Electrodes for Kinetic Analysis of Interactions on Membrane Surfaces
- Effect of Interstitial Elements on Hall-Petch Coefficient of Ferritic Iron
- Work-Hardening Mechanism during Super-Heavy Plastic Deformation in Mechanically Milled Iron Powder
- Conditions for Grain Boundary Bulging during Tempering of Lath Martensite in Ultra-low Carbon Steel
- Contribution of Soft Copper Particle on Work Hardening Behavior in Ferritic Iron
- Microstructure and Mechanical Property of Copper Bearing Eutectoid Steel
- Factors Inducing Intergranular Fracture in Nickel-free High Nitrogen Austenitic Stainless Steel Produced by Solution Nitriding
- Variant Selection of Reversed Austenite in Lath Martensite
- Effect of Solute Copper on Yield Strength in Dislocation-strengthened Steels
- Effect of Grain Refinement on Thermal Stability of Metastable Austenitic Steel
- Mechanism of Toughening in Ferritic Iron by Solute Copper at Low Temperature
- Effect of Grain Refinement on Tensile Properties in Fe-25Cr-1N Alloy
- Step Aging of a Sintered Ti-13mass%Cr β Alloy
- 3D Surface Profile Measurement of Moving Object Using Linear Sensors(Optical Method 2)
- Focused ion beam fabrication of field-ion microscope specimens from mechanically milled pearlitic steel powder
- Calculation of Nitrogen Absorption into Austenitic Stainless Steel Plate and Wire
- Structural Control of Stainless Steel by Nitrogen Absorption in Solid State
- Phase Transformation Mechanism of Fe-Cu Alloys
- Fabrication of Fine-grained High Nitrogen Austenitic Steels through Mechanical Alloying Treatment
- Interaction between Dislocation and Copper Particles in Fe-Cu Alloys
- Strengthening Mechanism of Cu bearing Heat Resistant Martensitic Steels
- Effect of Partial Solution Treatment on Toughness of 12%Cr-0.3%C Steels
- Self-Division Behavier of TiB Particles in TiB/Ti Composite
- Effect of Initial Microstructure on Superplasticity in Ultrafine Grained 18Cr-9Ni Stainless Steel
- Temperature Dependence of Austenite Nucleation Behavior from Lath Martensite
- Effect of Phosphorus on Hall-Petch Coefficient in Ferritic Steel
- Strengthening Mechanism in Ultra Low Carbon Martensitic Steel
- Isothermal Transformation in Fe–N Hypereutectoid Alloy
- Optimal Chemical Composition in Fe-Cr-Ni Alloys for Ultra Grain Refining by Reversion from Deformation Induced Martensite.
- Isothermal Transformation in Fe-N Hypereutectoid Alloy
- Mechanical Properties of Strength-Gradient Steel Sheets Produced by Solution Nitriding