Numerical Analysis of the PHEBUS Containment Thermal Hydraulics
スポンサーリンク
概要
- 論文の詳細を見る
This paper describes numerical analysis of the PHEBUS FP containment thermal-hydraulics. PHEBUS FP is an international project undertaken with the aim of evaluating the behavior of radioactive fission products released from a LWR pressure vessel into the containment vessel during a hypothetical severe accident. Six integral in-pile tests have been planned and are being carried out at Cadarache, France. The European Union, the United States, Canada, Korea and Japan are participating in this project. From Japan, the Nuclear Power Engineering Corporation and the Japan Atomic Energy Research Institute are collaborating the other parties involved in the project. <BR>Since the behavior of fission products is strongly dependent on the surrounding environmental conditions, accurate prediction of the thermal-hydraulics in the containment vessel is essential to accurately evaluate the behavior. Characteristics of condensation heat transfer in the presence of noncondensable gases play a key role in the PHEBUS thermal-hydraulics, especially under the condition of high noncondensable gas mass fraction. Many models for condensation heat transfer in the presence of noncondensable gases have been proposed. However, these models were not found suitable for PHEBUS analysis, because they were focused on the low noncondensable gas mass fraction condition.<BR>In this study, a single-phase multi-component code, TFLOW-FP has been newly developed to predict thermal-hydraulics in the PHEBUS FP containment. Moreover, a new degradation factor correlation for the condensation heat transfer coefficient due to the presence of noncondensable gases has also been developed and incorporated into the code. This code was applied for analysis of the thermal-hydraulic benchmark tests and the first in-pile test, FPTO. The results show that the code can predict the total pressure, gas temperature distributions, the relative humidity in the containment vessel and steam condensation rate on the surface of condenser rods very well.
- 社団法人 日本原子力学会の論文
- 1997-07-25
著者
-
Terasaka Haruo
Systems Safety Department Nuclear Power Engineering Corporation
-
MAKITA Atsushi
Analysis Department, Toshiba Advanced System Corporation
-
Makita Atsushi
Analysis Department Toshiba Advanced System Corporation