Phosphorus Particle Composite Plating with Ni-P Alloy Matrix
スポンサーリンク
概要
- 論文の詳細を見る
Ni-P alloy films containing phosphorus particles (called Ni-P alloy composite films) were fabricated by electrodeposition and were subsequently subjected to heat-treatment. Their compositions and microstructures were characterized, and their friction properties were evaluated using a ball-on-plate method. Composite electroplating in the nickel sulfate and chloride bath containing phosphorus acid and micrometer-sized phosphorus particles resulted in the Ni-P alloy coating with enhanced deposit phosphorus content. The phosphorus content of the films increased with increasing phosphorus particle concentration in the composite plating baths, reaching a maximum value of 29.0 atom %. The phosphorus particles were homogeneously distributed in this Ni- 29.0 atom % P alloy composite film. Heat-treatment converted the phases of the alloy composite films from an amorphous phase to stable crystalline phases, which are the same as those in the Ni- P binary alloy phase diagram. The friction coefficients of the Ni- P alloy films increased with increasing cycle number, whereas those of the Ni- P alloy composite films remained relatively constant. The alloy composite films had lower friction coefficients than the Ni- P alloy films both before and after heat-treatment. These results indicate that phosphorus particles are beneficial for maintaining a lower and stable friction coefficient during the ball-on-plate reciprocating friction test.
- ELECTROCHEMICAL SOC INCの論文
- 2009-07-04
ELECTROCHEMICAL SOC INC | 論文
- Electrodeposition of Ni-P Alloy-Multiwalled Carbon Nanotube Composite Films
- Low-internal-stress nickel multiwalled carbon nanotube composite electrodeposited from a sulfamate bath
- Cu/Multiwalled Carbon Nanotube Composite Films Fabricated by Pulse-Reverse Electrodeposition
- Effects of Additives on Cu-MWCNT Composite Plating Films
- Boron Particle Composite Plating with Ni-B Alloy Matrix