A Study on the Formation of Cu-Al2O3 Composite Particles by Mechanofusion – A Consideration on the Formation relating to the Effects of Vacuum and Temperature Increase of Particle Surfaces – [Transl
スポンサーリンク
概要
- 論文の詳細を見る
A mechanofusion apparatus which can operate at a high vacuum pressure of the order of 10-2 Pa was developed. Using this apparatus, formation of Cu composite with Al2O3 core particles was conducted. The rate of progress of composite formation was low under atmospheric or low vacuum conditions but under a high vacuum or in an Ar displaced atmosphere, such formation was remarkably accelerated. Namely, it was found that composite formation is greatly accelerated by lowering the oxygen partial pressure. Following oxygen analysis of the Cu covering layer of composite particles by AES, it was found that with a higher atmospheric pressure, the oxygen amount became higher and oxygen penetrated into the interior. As a result of microstructure observations of the composite particles to which extended mechanofusion processing and chemical etching had been applied, grain boundaries were observed in the Cu covering layer which may imply that the Cu particle surface becomes exposed to high temperature as more sintering occurs. This microstructure is very similar to the structure of Cu after high temperature annealing. The individual particle surface temperatures during mechanofusion was estimated as being around 1000 K from the experimental results of sintering behavior of cold pressed Cu. † This report was originally printed in Journal of the Japan Society of Powder and Powder Metallurgy, 39(12), 1124-1128, 1129-1133 (1992) in Japanese, before being translated into English by KONA Editorial Committee with the permission of the editorial committee of Japan Society of Powder and Powder Metallurgy.
- 公益財団法人 ホソカワ粉体工学振興財団の論文
公益財団法人 ホソカワ粉体工学振興財団 | 論文
- Flowsheet Simulation of Solids Processes
- Aggregate Structures and Solid-Liquid Separation Processes
- Generation and Sizing of Particles for Aerosol-Based Nanotechnology
- Powder Processing Issues for High Quality Advanced Ceramics
- Development of an Apparatus for Measuring Adhesive Force between Fine Particles [Translated]†