Flow and Heat Transfer Characteristics in a Two-Phase Loop Thermosyphon:The Case Where an Evaporator Has Three Heated Tubes
スポンサーリンク
概要
- 論文の詳細を見る
A two-phase loop thermosyphon transports thermal energy from a heat source to a heat sink by natural convective circulation under a body force field without any external power supply such as a pump. It is, therefore, thought that this could be applied to an energy-saving heat transportation system, and so forth. In practical use, an evaporator has several heated tubes and also the heat supplied to each of the heated tubes is not always equal. Therefore, the present study was performed both experimentally and theoretically on the flow and heat transfer characteristics in the two-phase loop thermosyphon installed with the evaporator with three heated tubes as a comparatively simple multi-tube evaporator in the lower part of the loop. The circulation mass flow rate, pressure and temperature distributions along the loop, as well as the heat transfer coefficients in the heated tubes were measured using water, ethanol and benzene, on which the effects of subcooling at the evaporator inlet and a heat input ratio of the three heated tubes were examined, and the experimental data were compared with the theoretically calculated results.
- 公益社団法人 日本冷凍空調学会の論文
公益社団法人 日本冷凍空調学会 | 論文
- 液滴の過冷却凝固について:-食塩水溶液-
- 水‐油エマルションを用いた氷蓄熱のための容器内撹はん製氷 臨界表面張力の小さな壁面材質の熱抵抗が製氷過程に与える影響について:臨界表面張力の小さな壁面材質の熱抵抗が製氷過程に与える影響について
- 水‐油エマルションを用いた氷蓄熱のための容器内撹はん製氷 エマルションの組成が製氷過程に与える影響について:(エマルションの組成が製氷過程に与える影響について)
- クロスフィンチューブ熱交換器におけるフィンカラー形状が伝熱性能に及ぼす影響
- マイクロガスタービン・固体酸化物形燃料電池複合発電による分散エネルギーシステムの性能解析と最適運用計画