Improvement of Anti-fatigue Property of Contact Wire by Modifying Cross-section Shape
スポンサーリンク
概要
- 論文の詳細を見る
Bending strain, which exerted on contact wire with every pantograph passage, may cause fatigue of contact wire. We designed a cross-section shape of contact wire in an attempt to reduce this bending strain. We confirmed that this cross-section shape did not make worse galloping property (property of vertical vibration caused by a cross wind) through wind tunnel tests. We also confirmed that this cross-section shape could be applied to manufacturing contact wire with high strength copper alloy through trial manufacture. Compatibility with fittings (hanger ears, double ears, termination fittings, etc.) was tested with this trial piece and no problems were found. A meaningful decrease in bending strain was observed in pantograph running tests.
- 公益社団法人 鉄道総合技術研究所の論文
公益社団法人 鉄道総合技術研究所 | 論文
- Measurement of the Contact Force of the Pantograph by Image Processing Technology
- Simulation of Passenger Behavior on Board a Commuter Train in the Event of a Level Crossing Accident
- Predicting Concrete Deterioration due to Chloride Corrosion of Reinforcing Bars
- Neutral Point Bias Control Method for Large Capacity Inverter.
- Totally Enclosed Permanent Magnet Synchronous Motor for Commuter Trains