可視化法による液体｀３´Ｈｅの沸騰観測
スポンサーリンク
概要
- 論文の詳細を見る
The behaviors of bubble nucleation and growth in liquid 3He were investigated visually using the shadowgraph method. We have constructed two types of cryostats and sample cells for measurements between 0.5 and 1K. The 3He bubble that formed on the heated copper surface was spheroid-like due to a low surface tension and small buoyancy force. The time for required for the bubble to grow and separate from the surface was 14ms at a heat flux of <rb>q. = 8=10-5 W/cm2 and bulk liquid 3He temperature of 0.7K. This means that the bubble growth rate is high as compared to other low-temperature liquids. The bubble size, number of bubbles separating from the heated surface in a specific time and the rising velocity of the bubbles were analyzed using photographs obtained from a high-speed camera as a function of heat flux and liquid 3He temperature. In the region of large heat flux, large bubbles formed by bubble accumulation covered the copper surface and the increase in bubble number as <rb>q. increased became insignificant. In this region, the amount of heat flux carried by bubbles as latent vaporization heat was approximately 60% of the applied heat flux. The characteristic heat transfer curve of liquid 3He measured previously by our group could be explained qualitatively by these boiling behaviors.
- 公益社団法人 低温工学・超電導学会 (旧 社団法人 低温工学協会)の論文
公益社団法人 低温工学・超電導学会 (旧 社団法人 低温工学協会) | 論文
- Test Results of the SMES Model Coil. Cool-down and Thermal Characteristics.:Cool-down and Thermal Characteristics
- Crystal Growth of Y Based Superconductors on Solidification Processing.
- Refrigeration of pressurized He II using a 3He circulation system. (II). Behavior of the system during the initial cooling and after a pulsed heat generation.:Behavior of the System during the Initial Cooling and after a Pulsed Heat Generation
- Quench simulation analysis of a superconducting coil. II. Simulation.:II. Simulation
- タイトル無し