Occlusal contacts of crown in the intercuspal position after occlusal adjustment.
スポンサーリンク
概要
- 論文の詳細を見る
The purposes of occlusal adjustment of a crown are: to make the crown be harmonious to the dental arch in the intercuspal position; to maintain occlusal pattern in mandibular movements; and to build up numbers of occlusal contact points, contact area and contact sections that are similar to the adjacent teeth.<BR>In the ordinary indirect method, the height of the crown is excessively high as a cast, 200-300μm, at intercuspal position. But, its height is proper only at intercuspal position in accuracy of a few μm, by means of occlusal adjustment using burs, abrasive points and articulating paper.<BR>The aim of this investigation is to find out whether there are occlusal contact points with an accuracy of a few 10μm at intercuspal position and those in each cusp of crown, after occlusal adjustment during lateral and protrusive excursions.<BR>Crowns were made on upper and lower molar teeth for each of 10 subjects. The occlusion of the crowns was adjusted in the ordinary clinical method before cementing by means of observation, tactile sensibility and an articulating paper pull-out test and occlusal contact pattern as index. After occlusal adjustment, the silicone-black method was used for estimating the occlusal contact in the intercuspal position. As for three out of ten cases, the occlusal contact of crowns was analyzed. In trial, temporary cementation and cementing of crowns, and after a week of cementation, occlusal contact patterns were taken on the articulating paper and the silicone-black. They were also observed by microscope and visual scaler.<BR>As a result, occlusal contact sections were located on the incline of cusp or marginal ridges, and occlusal contact points were limited in near contact parts of facets shown on the silicone-black, which were made in occlusal adjustment. In the process of the occlusal adjustment, the number of occlusal contact points were gradually increased and contact areas became smaller.<BR>Conclusions are as follows:<BR>1. It is not necessarily easy to make occlusal contact point on each cusp of crown at intercuspal position.<BR>2. Estimation should be done of the near contact part with relation to occlusal contact.
- 日本顎口腔機能学会の論文
日本顎口腔機能学会 | 論文
- 1. 咬合接触と咀嚼機能(第30回学術大会)
- 骨格性下顎前突の外科的矯正治療前後における下顎運動の変化
- 11.骨格性下顎前突症患者における嚥下時筋活動パターンの定量的評価
- 日本顎口腔機能学会第31回学術大会報告
- 5. 顎関節の潤滑メカニズムに関する咬合の影響(第31回学術大会)