Production of Submicron Particles by Autogenous Grinding with a Stirred Mill.
スポンサーリンク
概要
- 論文の詳細を見る
The stirred mill is regarded as one of the most efficient devices for micronizing materials and have come to be actively used for preparation of fine particles. Recently, a demand for ultrafine particles is increasing in many kind of industries.<BR>In this paper, based on frictional action of feed material each other, an autogenous grinding to get submicron or micronized particles have been carried out using a stirred mill (Attritor-type D). The mill used was made of stainless steel and its volume was about 5.5 liters. The mill held 12 impellers. In the present work, two operating parameters such as stirring speed and feed size of limestone were used. The feed mass was 5 kg and three different feed size were chosen for this experiment: 6.7-10, 10-13, 13-20mm. The rotational speed of impeller examined were 69, 103 and 139 rev/min. The ground products were sieved in the size range from feed size to 149, u m, and from 149 to 0.17, a m, the size distributions were measured by a laser diffraction and scattering method<BR>The torque reading were recorded during each experiment, and the area under the torque vs. grinding time curve was used to give a measure of the total energy input to the mill. The grinding time were 2, 4, 10, 25, 40, 60 and 180 min. The progress of grinding was evaluated by the increasing rate of submicron or micronized particles in products.<BR>The results are summarized as follows<BR>(1) The zero-order equation was applicable to the increasing rate of submicron particles in earlier grinding time. (2) The energy consumption to get submicron particles decreased with increase in the feed size at all speed of impeller.<BR>(3) It was minimum when the feed size was 13-20mm, that is, close to the distance between the top edge of impeller and the wall of mill. (4) The following experimental equation was obtained. Q<SUB>1</SUB>= (5.6×10<SUP>-9</SUP>-3.2×10<SUB>-11</SUB>n) E·x<SUB>fm</SUB> where Qi is the mass fractiom finer than 1μEm, n the rotational speed of impeller, E the energy consumption and x<SUB>fm</SUB> the maximum size in the feed.<BR>(5) It was found the an autogenous grinding with a stirred mill is an effective method producing submicronized limestone.
- 日本素材物性学会の論文
日本素材物性学会 | 論文
- 定常流体軸力におよぼすスプ-ル弁スリ-ブ流入出部形状の影響
- フキ属植物のセスキテルペン類
- 磁気駆動回転アークによる気体加熱の研究
- 表面プラズモン共鳴法による薬剤 : タンパク質相互作用測定におけるセンサ表面へのタンパク質固定化状態の効果の検証
- 超音波計測時の固体接触部からの高調波発生に関する実験的検討