Production and Material Properties of Ceramic from Waste Glass Fiber Reinforced Plastic

スポンサーリンク

概要

• 論文の詳細を見る

• We produced porous glass fiber reinforced ceramic by mixing clay and crushed waste glass fiber reinforced plastic (GFRP) before firing the mixture. Sprues and runners, which are by-products from the manufacture of plastic merchandise by injection molding, were used as waste GFRP. By observing the ceramic microstructure and examining its strength, it was confirmed that porous ceramic reinforced by glass fiber could be produced. In addition, to examine the environmental suitability of the ceramic, the pH of immersion liquid was measured and acid resistance tests were carried out. The immersion solution of the ceramic was neutral or slightly alkaline, the mass loss of the ceramics in the acid resistance test was small and the reduction in bending strength after the tests was also very small. The ceramic is considered to be environmentally benign. The results suggest that the manufacture of porous glass fiber reinforced ceramic can be an effective means to recycle waste GFRP. It is expected that the ceramic could be used as a construction material because of its lightweight, high strength properties and environmental suitability.

• 一般社団法人 日本機械学会の論文

著者

• Kinoshita Hiroyuki

  Department Of Anesthesia Kurashiki Central Hospital

• Ando Takahiro

  Department Of Anesthesiology And Critical Care Medicine Kasugai Municipal Hospital

• KAIZU Koichi

  Department of Mechanical and System Engineering, Graduate School of Engineering, University of Hyogo

• IKEDA Kiyohiko

  Department of Mechanical Systems Engineering University of Miyazaki

• HASEGAWA Shintaro

  Department of Mechanical Systems Engineering, University of Miyazaki

• KAWAMURA Ryuusuke

  Department of Mechanical Systems Engineering, University of Miyazaki

• KOBAYASHI Taichi

  Center for Collaborative Research & Community Cooperation, University of Miyazaki

• FUKUYAMA Hanako

  Center for Collaborative Research & Community Cooperation, University of Miyazaki

関連論文

• Severe Duodenal Hemorrhage Induced by Lugols Solution Administered for Thyroid Crisis Treatment
• Transient phlebitis induced by a bolus injection of propofol
• Nutritional Effects of γ-Glutamyl Carboxylase Gene Polymorphism on the Correlation between the Vitamin K Status and γ-Carboxylation of Osteocalcin in Young Males
• The Role of Endothelium-Derived Nitric Oxide in Relaxations to Levcromakalim in the Rat Aorta
• Plane Elastic Behavior and Stress Intensity Factor for an Inhomogeneous Slab with a Griffith Crack
• Effects of halothane and isoflurane on acetylcholine-induced, endothelium-dependent vasodilation in perfused rat mesenteric arterial beds
• The Role of Oxygen-Derived Free Radicals in Augmented Relaxations to Levcromakalim in the Aorta From Hypertensive Rats
• Pharmacological Significance of the Blocking Action of the Intravenous General Anesthetic Propofol on the Slow Component of Cardiac Delayed Rectifier K^+ Current
• Dynamic Behavior of Thick Plates Due to Oblique Impact : Numerical Analysis of Three-Dimensional Stress Waves in an Elastic/Viscoplastic Body
• A CASE OF SUBMANDIBULAR HEMANGIOMA WITH PHLEBOLITH
• Output Feedback Control of Multirate Sampled Systems with an Adaptive Output Estimator and Its Application to a Liquid Level Process Control
• 529 Experimental and Numerical Simulations of the Riveting Process by Upset Forging
• Leakage from a nonelectric disposable pump
• Benzoyl peroxide : a cause of skin injury in Japan?
• EFFECTS OF Ca^-ANTAGONISTS ON THE TRANSIENT INWARD CURRENT IN GUINEA-PIG PAPILLARY MUSCLE : Arrhythmias (I), Electrophysiology (II) : III : 48 Annual Scientific Meeting, Japanese Circulation Society
• A trial to Evaluate Experimentally Induced Delayed Onset Muscle Soreness and Its Modulation by Vibration
• FLEXURAL FAILURE BEHAVIOR OF POROUS CONCRETE
• Acremolactone A, a Novel Herbicidal Epoxydihydropyranyl γ-Lactone from Acremonium roseum I4267
• Effect of Friction Welding Condition on Joining Phenomena and Tensile Strength of Friction Welded joint between Pure Copper and Low Carbon Steel
• Serotonin syndrome induced by dextromethorphan (Medicon) administrated at the conventional dose
• Operating table failure and suggested safety precautions
• Production of High-Strength Glass-Ceramics from Industrial Wastes Using Phase Equilibrium Diagram of CaO-Al2O2-SiO2 System
• Is out-of-hospital intubation by paramedics valid enough to be continued?
• The effect of airway narrowing and dead space on the shape of the capnogram
• Effects of oxidative stress on vascular function, and the role of anesthetics
• Joint Strength and Their Improvement of Type 5052 Aluminum Alloy Autocompleting Friction Welded Joint
• Development of High Strength Fly Ash Glass Ceramics: Influence of Additive on Material Properties
• The Fatigue Crack Growth Behavior in Thermally Tempered Glass by the Growth of Indentation-Induced Microcracks
• Production and Material Properties of Ceramic from Waste Glass Fiber Reinforced Plastic
• Impact Fracture Analysis of Thermally Tempered Glass by the Extended Distinct Element Method

もっと見る 閉じる

スポンサーリンク